Splashbacks and tiling in Wellington

When do splashbacks and tiling make sense in Wellington?

Some households in Shropshire want tiling taken up to the ceiling behind a range cooker or open shelving, turning one whole wall into a practical feature that is easy to wipe down.

If the kitchen in your Wellington home is sound but the tiles are dated, cracked or stained, a new splashback is one of the simplest ways to refresh it without replacing units. Wellington sits about 3 miles north-west of Telford, and our Shropshire coverage takes in everything in between.

What is in a typical job?

Your written quote lists everything included. For splashbacks and tiling, that normally means:

Stone upstands and splashbacks templated and fitted alongside a stone worktop
Toughened glass splashback measured after the worktops are fitted, with socket cut-outs
Full-height or feature tiling behind the hob, sink or open shelving
Socket and switch plates refitted by an electrician once the tiling is finished
Tiled splashbacks between the worktop and wall units, set out from a centre line
Old tiles removed and walls prepared, patched or boarded where needed

Guide prices for splashbacks and tiling in Wellington

These guide ranges include VAT at 20% and are adjusted for prices in the West Midlands. We confirm your price in writing after a free survey visit. Costs in the West Midlands sit close to the national guide.

Guide prices for splashbacks and tiling in Wellington
Typical project	Guide price
Tiled splashbackBetween worktop and wall units	£150–£400
Kitchen wall tiling, 4–6 m²Preparation, tiling and grouting	£300–£800
Toughened glass splashback behind the hob, fittedMade to measure after the worktops are in	£250–£600
Stone upstands and splashbacksTemplated with the worktop	Priced with the worktop

Tiling guide ranges cover preparation, adhesive, grout, trims and fixing, with the tiles themselves confirmed once chosen; the glass range includes a made-to-measure panel, and stone upstands are priced with the worktop. Prices include VAT at 20%.

House types around Wellington and what they mean for a kitchen

You will find timber-framed cottages, Victorian terraces, post-war new town houses and farmhouses throughout Shropshire. Telford's new-town houses often have a compact galley or L-shaped kitchen, while older cottages in Shrewsbury and Ludlow may have small rooms with low beams.

Much of Shropshire has moderately hard to hard water, so limescale on taps and boiling water taps is worth planning for; check with your supplier. Rural lanes, farm tracks and medieval town centres with restricted parking can all complicate deliveries, so vehicle size and timing are planned in advance.

What rules apply to splashbacks and tiling in Wellington?

Tiling or fitting a splashback in England needs no planning permission or building regulations approval. If sockets or switches are moved to suit the new wall finish, that is electrical work to BS 7671; adding to an existing kitchen circuit is not notifiable under Part P, but a new circuit is. Behind a gas hob, follow the hob maker's clearance instructions, and in a listed building, removing historic tiles or panelling may need listed building consent.

Shrewsbury and Ludlow have many listed timber-framed buildings and conservation areas, so new vents or internal alterations may need listed building consent or planning permission.

Planning ahead

Ask to see where the tiling will start before the first row goes on in your Wellington kitchen, so narrow cut tiles end up in corners rather than on show.
Give fresh grout and sealant the full curing time shown on the packaging before scrubbing them or letting water sit on the joint at the back of the worktop.
Keep the tile boxes until the job is finished and note the batch number, so matching replacements can be found if a tile cracks later.
Pale grout behind a hob or sink shows stains quickly; a mid-grey or stain-resistant grout in narrow joints is easier to keep looking fresh.

Questions about splashbacks and tiling in Wellington

How much do splashbacks and tiling cost in Wellington?

For a tiled splashback, budget around £150 to £400 including VAT in Wellington. That reflects typical costs in the West Midlands; we confirm the actual figure in writing once we have measured up.

Can you measure up in Wellington before quoting?

Yes. Every quote starts with a free, no-obligation survey visit to your home in Wellington. We measure the room, check the walls, floor and service positions, then send an itemised written quote.

Can you tile over existing kitchen tiles?

Sometimes, but it is rarely the better choice in a kitchen. Tiling over old tiles adds thickness, so sockets, switches and the edge against the wall units may no longer line up, and the new tiles rely on the old ones staying firmly bonded. If the existing tiles are sound and flat it can work for a small area; otherwise we remove them and prepare the wall.

When are splashbacks fitted during a kitchen installation?

Splashbacks go on near the end, once the worktops are fixed and the electrician has agreed where the sockets and switches will sit. Tiles need a finished worktop to start from, glass is measured off the fitted worktop, and stone upstands are templated at the same visit as the worktop. Faceplates go back on after tiling, so the sockets sit neatly against the new finish.

Can heavy tiles or stone go on any kitchen wall?

Not always. Heavy tiles such as large-format porcelain or natural stone need a backing that can carry their weight and an adhesive suited to both the tile and the wall. Old plaster, painted plaster or plasterboard may need preparing, priming or replacing with a tile backer board first. We check the wall at the survey and follow the tile and adhesive makers' guidance.

Splashbacks and tiling near Wellington

The same service is available a short drive from Wellington, including: