Cooker hood installation in Fleetwood

Is cooker hood installation right for your Fleetwood kitchen?

If condensation runs down the windows of your Fleetwood kitchen whenever you cook, the hood may be recirculating, undersized or ducted through a long, flexible run.

Cooks across Lancashire who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead. Our Lancashire coverage reaches every part of Fleetwood (FY7) and out towards Thornton-Cleveleys.

What is in a typical job?

After the survey visit we write the scope down. For cooker hood installation in Fleetwood it usually covers:

Survey of the hob position, duct route, outside wall and any open-flued appliance
Short, straight runs of rigid ducting wherever the route allows
Core drilling through the outside wall and an external grille fitted and sealed
Power supply connected by an electrician and tested to BS 7671
Hood fixed at the height set by the hood and hob manufacturers
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present

What does cooker hood installation cost in Fleetwood?

The figures below are guide prices for Fleetwood, including VAT and adjusted for typical costs across the North West. The fixed price comes after we have measured up. Prices in the North West usually come in below the national guide, as labour rates are lower than in the South East.

What does cooker hood installation cost in Fleetwood?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£110–£230
New ducted hood through an outside wallCore drilling, ducting run and external grille	£280–£860
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£280–£600
Recirculating hood fittedNo ducting; carbon filters need replacing	£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Kitchens in homes around Fleetwood

In and around Fleetwood, homes range across stone-built mill-town terraces, red-brick Victorian terraces, 1930s semis and seaside bungalows. Mill-town terraces often have a small back kitchen opening onto a yard, while seaside bungalows and 1930s semis tend to have a square kitchen at the rear.

Back alleys and yards can help with deliveries, though narrow yard gates and steep hill streets may limit how long worktops come in. Most of Lancashire has soft mains water, so heavy limescale is rare and taps, sinks and appliances stay cleaner for longer.

Building regulations, electrics and gas in Fleetwood

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Where an older town-centre home is listed or in a conservation area, a new vent on a front wall may need consent, and flats in converted houses usually need freeholder approval.

Worth knowing before the fit

Before choosing a hood for your Fleetwood kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
For an island or ceiling hood, find out what is above the ceiling, as joists or added timbers are needed to carry the weight securely.

Questions about cooker hood installation in Fleetwood

How much does cooker hood installation cost in Fleetwood?

Cooker hood installation in Fleetwood typically costs £110 to £230 including VAT for a like-for-like cooker hood swap, based on prices in the North West. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.

Do you cover all of Fleetwood?

Yes. We work across Fleetwood, including the FY7 postcode district, and nearby towns such as Thornton-Cleveleys and Poulton-le-Fylde. Book a free survey visit and we will arrange a time that suits you.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

How high should a cooker hood be above the hob?

At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.

Cooker hood installation near Fleetwood

Close to Fleetwood? We cover these nearby towns too: