Cooker hood installation in Poulton-le-Fylde

What prompts cooker hood installation in Poulton-le-Fylde?

Cooks across Lancashire who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead.

If your Poulton-le-Fylde kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test. Our Lancashire coverage reaches every part of Poulton-le-Fylde (FY6) and out towards Blackpool.

What is included in the work?

Here is what usually goes into cooker hood installation, adjusted to your Poulton-le-Fylde kitchen after we have measured it:

Island and ceiling hoods fixed into the ceiling structure by two people
Recirculating hoods fitted with carbon filters, and their limits explained
Survey of the hob position, duct route, outside wall and any open-flued appliance
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Power supply connected by an electrician and tested to BS 7671
Core drilling through the outside wall and an external grille fitted and sealed

What does cooker hood installation cost in Poulton-le-Fylde?

Use these ranges to plan your budget. They include VAT, reflect costs in the North West, and are firmed up once we have seen your Poulton-le-Fylde kitchen. Labour rates in the North West are generally lower than in London and the South East, so these ranges are a little below the national guide.

What does cooker hood installation cost in Poulton-le-Fylde?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£110–£230
New ducted hood through an outside wallCore drilling, ducting run and external grille	£280–£860
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£280–£600
Recirculating hood fittedNo ducting; carbon filters need replacing	£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

What kind of kitchens do we fit in Poulton-le-Fylde?

Typical homes in this part of Lancashire include stone-built mill-town terraces, red-brick Victorian terraces, 1930s semis and seaside bungalows. Mill-town terraces often have a small back kitchen opening onto a yard, while seaside bungalows and 1930s semis tend to have a square kitchen at the rear.

Most of Lancashire has soft mains water, so heavy limescale is rare and taps, sinks and appliances stay cleaner for longer. Back alleys and yards can help with deliveries, though narrow yard gates and steep hill streets may limit how long worktops come in.

What rules apply to cooker hood installation in Poulton-le-Fylde?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Where an older town-centre home is listed or in a conservation area, a new vent on a front wall may need consent, and flats in converted houses usually need freeholder approval.

Tips before you start

Before choosing a hood for your Poulton-le-Fylde kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
For an island hood in your Poulton-le-Fylde kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.

Questions about cooker hood installation in Poulton-le-Fylde

How much does cooker hood installation cost in Poulton-le-Fylde?

Guide prices in Poulton-le-Fylde are about £110 to £230 including VAT for a like-for-like cooker hood swap. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.

Do you cover all of Poulton-le-Fylde?

Yes. We work across Poulton-le-Fylde, including the FY6 postcode district, and nearby towns such as Blackpool and Thornton-Cleveleys. Book a free survey visit and we will arrange a time that suits you.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Nearby places we cover

We also carry out cooker hood installation in these towns near Poulton-le-Fylde: