Kitchen flooring in Romford

Why do people in Romford choose kitchen flooring?

If your home in Greater London has suspended timber floorboards, a plywood overlay usually goes down first so tiles or LVT do not crack or show the board joints.

Families across Greater London often choose LVT for a kitchen because it is warmer and quieter underfoot than tiles and copes well with spills and dropped cups. Homes right across Romford are covered, as are nearby places such as Hornchurch, Dagenham and the villages in between.

What is in a typical job?

Here is what usually goes into kitchen flooring, adjusted to your Romford kitchen after we have measured it:

Flooring run under appliance spaces so machines can be pulled out for servicing
Underlay suited to the floor finish, the subfloor and any underfloor heating
Old coverings lifted and removed, with pre-2000 floor tiles checked for asbestos first
Free survey visit to check the subfloor, measure up and give an itemised quote
Moisture checks on concrete floors and screeds before any floor finish is laid
Levelling compound or a plywood overlay to give a flat, firm base

Kitchen flooring prices in Romford

As a starting point for Romford, these ranges include VAT at 20% and allow for typical labour costs in London. Prices in London usually run above the national guide, mainly because labour and parking cost more.

Kitchen flooring prices in Romford
Typical project	Guide price
LVT or vinyl, kitchen floorPreparation, underlay where needed and trims	£650–£2,000
Porcelain or ceramic tiles, kitchen floorPreparation, adhesive, grout and trims	£1,200–£2,600
Floor levelling or new plywood baseSo the floor finish and units sit flat	£390–£1,200

Guide prices are for a typical-sized kitchen floor, including preparation, adhesive or underlay and trims; the material you choose, open-plan floor areas and any levelling or plywood base are confirmed at the survey. Prices include VAT at 20%.

Fitting kitchens in older and newer Romford homes

The housing mix across Greater London includes Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis, so no two kitchen fits are quite alike. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in. Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day.

Regulations for kitchen work in Romford

A new kitchen floor in England needs no planning permission or building regulations approval. In a flat, check the lease first: leases often require a sound-reducing underlay, or forbid hard floors without the freeholder's consent. If electric underfloor heating goes under the new floor on a new circuit, that circuit is notifiable under Part P. In a listed building, removing historic floors may need listed building consent.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Before you book kitchen flooring in Romford

Keep pets and children off a newly tiled floor until the grout has set, and put felt pads on chair legs if your Romford kitchen has LVT or wood.
Ask for the floor to continue under the dishwasher and fridge spaces, so appliances can be slid out for repair without lifting the edge of the floor.
If your Romford house was built before 2000 and still has old vinyl or thermoplastic tiles, have them tested for asbestos before anyone lifts or sands them.
Engineered wood can suffer near sinks and dishwashers, where leaks and standing water are most likely, so it may be less suited than LVT or tiles.

Questions about kitchen flooring in Romford

How much does kitchen flooring cost in Romford?

For an LVT or vinyl kitchen floor, budget around £650 to £2,000 including VAT in Romford. That reflects typical costs in London; we confirm the actual figure in writing once we have measured up.

Do you cover all of Romford?

Yes. We work across Romford, including the RM1 postcode district, and nearby towns such as Hornchurch and Dagenham. Book a free survey visit and we will arrange a time that suits you.

Does my kitchen floor need levelling before new flooring?

Often, yes. Thin floors such as LVT and sheet vinyl show every dip and ridge underneath, and tiles can crack if the base flexes or is uneven. Concrete floors are usually smoothed with a levelling compound, while timber floorboards are normally overlaid with plywood screwed down at close centres. We check the floor at the survey and price any preparation as its own line.

Is engineered wood a good choice for a kitchen floor?

It can be, but it needs more care than LVT or tiles. Engineered wood can swell or stain if water sits on it, so it is less suited to the areas around a sink or dishwasher, where leaks are most likely. If you choose it, pick a board the maker approves for kitchens, wipe spills promptly and keep the finish maintained.

Should kitchen flooring go down before or after the units?

It depends on the floor. Tiles are often laid first, or at least run under the appliance spaces, so a dishwasher or fridge can be pulled out without catching on the edge. Floating floors such as click LVT or engineered boards usually go down after the units, up to the plinth line, so they are not trapped under heavy fixed cabinets. We follow the flooring maker's instructions.

Also covering nearby towns

The same service is available a short drive from Romford, including: