Splashbacks and tiling in Romford

Is splashbacks and tiling right for your Romford kitchen?

Landlords around Greater London often prefer plain tiles with mid-grey grout or a glass panel, since both stand up to heavy use and are quick to clean between tenancies.

If the units in your Romford kitchen are already fitted and only the walls are unfinished, we can take on the tiling or splashback as a job on its own. Homes right across Romford are covered, as are nearby places such as Hornchurch, Dagenham and the villages in between.

What is included in the work?

Your written quote lists everything included. For splashbacks and tiling, that normally means:

Toughened glass splashback measured after the worktops are fitted, with socket cut-outs
Socket and switch plates refitted by an electrician once the tiling is finished
Tiled splashbacks between the worktop and wall units, set out from a centre line
Full-height or feature tiling behind the hob, sink or open shelving
Stone upstands and splashbacks templated and fitted alongside a stone worktop
Old tiles removed and walls prepared, patched or boarded where needed

Splashbacks and tiling prices in Romford

Typical splashbacks and tiling prices for homes in Romford, including VAT and adjusted for London. Your own figure depends on the size of the kitchen, the layout and what is moving. Prices in London usually run above the national guide, mainly because labour and parking cost more.

Splashbacks and tiling prices in Romford
Typical project	Guide price
Tiled splashbackBetween worktop and wall units	£200–£520
Kitchen wall tiling, 4–6 m²Preparation, tiling and grouting	£390–£1,000
Toughened glass splashback behind the hob, fittedMade to measure after the worktops are in	£320–£780
Stone upstands and splashbacksTemplated with the worktop	Priced with the worktop

Tiling guide ranges cover preparation, adhesive, grout, trims and fixing, with the tiles themselves confirmed once chosen; the glass range includes a made-to-measure panel, and stone upstands are priced with the worktop. Prices include VAT at 20%.

Fitting kitchens in older and newer Romford homes

In and around Romford, homes range across Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

What rules apply to splashbacks and tiling in Romford?

Tiling or fitting a splashback in England needs no planning permission or building regulations approval. If sockets or switches are moved to suit the new wall finish, that is electrical work to BS 7671; adding to an existing kitchen circuit is not notifiable under Part P, but a new circuit is. Behind a gas hob, follow the hob maker's clearance instructions, and in a listed building, removing historic tiles or panelling may need listed building consent.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Getting the most from your splashbacks and tiling

If you are renting out a flat in Romford, a single glass panel or large plain tiles cut down the grout that needs cleaning at each check-out.
Choosing stone worktops for a Romford kitchen? Ask for upstand and splashback heights to be confirmed before the template visit, not after.
Give fresh grout and sealant the full curing time shown on the packaging before scrubbing them or letting water sit on the joint at the back of the worktop.
Order spare tiles from the same batch to cover cuts and breakages, and keep a few back so a later repair matches.

Questions about splashbacks and tiling in Romford

How much do splashbacks and tiling cost in Romford?

Guide prices in Romford are about £200 to £520 including VAT for a tiled splashback. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.

Do you cover all of Romford?

Yes. We work across Romford, including the RM1 postcode district, and nearby towns such as Hornchurch and Dagenham. Book a free survey visit and we will arrange a time that suits you.

Can heavy tiles or stone go on any kitchen wall?

Not always. Heavy tiles such as large-format porcelain or natural stone need a backing that can carry their weight and an adhesive suited to both the tile and the wall. Old plaster, painted plaster or plasterboard may need preparing, priming or replacing with a tile backer board first. We check the wall at the survey and follow the tile and adhesive makers' guidance.

Can a glass splashback go behind a gas hob?

Yes, usually, as long as the glass is toughened and the hob maker's instructions allow it. Toughened glass handles heat far better than ordinary glass, but a gas hob must still keep the clearances set out in its installation instructions, so we check those before ordering. The panel is measured after the worktops are fitted and made with cut-outs for sockets, because it cannot be cut once toughened.

When are splashbacks fitted during a kitchen installation?

Splashbacks go on near the end, once the worktops are fixed and the electrician has agreed where the sockets and switches will sit. Tiles need a finished worktop to start from, glass is measured off the fitted worktop, and stone upstands are templated at the same visit as the worktop. Faceplates go back on after tiling, so the sockets sit neatly against the new finish.

Splashbacks and tiling near Romford

We also carry out splashbacks and tiling in these towns near Romford: