Cooker hood installation in Wigston

Why do people in Wigston choose cooker hood installation?

Cooks across Leicestershire who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead.

If your Wigston house has thick solid walls, core drilling a neat hole for the duct takes the right equipment and careful positioning of the outside grille. Homes right across Wigston are covered, as are nearby places such as Oadby, Leicester and the villages in between.

What is in a typical job?

Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:

Hood fixed at the height set by the hood and hob manufacturers
Core drilling through the outside wall and an external grille fitted and sealed
Survey of the hob position, duct route, outside wall and any open-flued appliance
Island and ceiling hoods fixed into the ceiling structure by two people
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Power supply connected by an electrician and tested to BS 7671

What does cooker hood installation cost in Wigston?

Use these ranges to plan your budget. They include VAT, reflect costs in the East Midlands, and are firmed up once we have seen your Wigston kitchen. Prices across the East Midlands are broadly in line with UK averages.

What does cooker hood installation cost in Wigston?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£120–£230
New ducted hood through an outside wallCore drilling, ducting run and external grille	£290–£870
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£290–£610
Recirculating hood fittedNo ducting; carbon filters need replacing	£120–£290

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Local homes and their kitchens

The housing mix across Leicestershire includes Victorian terraces, 1930s semis, post-war estate houses and new-build estates, so no two kitchen fits are quite alike. Leicester's Victorian terraces often have a long galley behind the back room, while 1930s semis tend to have a small square kitchen with a door to the garden.

Leicestershire's water is mostly moderately hard to hard, so limescale on taps and boiling water taps is likely and a filter or softener can help. Densely parked terraced streets and homes without rear access can make unloading slow, so delivery times and the route for long worktops are worth agreeing early.

What rules apply to cooker hood installation in Wigston?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Listed buildings and conservation areas, including some village centres and older parts of Leicester, may need consent for a new external vent or changes to historic features.

Planning ahead

Before choosing a hood for your Wigston kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
For an island hood in your Wigston kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.

Questions about cooker hood installation in Wigston

How much does cooker hood installation cost in Wigston?

For a like-for-like cooker hood swap, budget around £120 to £230 including VAT in Wigston. That reflects typical costs in the East Midlands; we confirm the actual figure in writing once we have measured up.

Do you cover all of Wigston?

Yes. We work across Wigston, including the LE18 postcode district, and nearby towns such as Oadby and Leicester. Book a free survey visit and we will arrange a time that suits you.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Cooker hood installation near Wigston

Close to Wigston? We cover these nearby towns too: