Cooker hood installation · Scotland
Cooker hood installation in Moray
Our cooker hood installation work covers the whole of Moray, including Elgin, Forres and Buckie.
Thinking about cooker hood installation in Moray?
Some Moray households simply want a quieter, more effective hood after years of a noisy one that barely clears the steam above a busy family hob.
If your Moray house has thick solid walls, core drilling a neat hole for the duct takes the right equipment and careful positioning of the outside grille.
What does cooker hood installation in Moray include?
The exact scope is agreed after the survey, but a typical job in Moray covers:
- Survey of the hob position, duct route, outside wall and any open-flued appliance
- Hood fixed at the height set by the hood and hob manufacturers
- Core drilling through the outside wall and an external grille fitted and sealed
- Short, straight runs of rigid ducting wherever the route allows
- Island and ceiling hoods fixed into the ceiling structure by two people
- Recirculating hoods fitted with carbon filters, and their limits explained
- Power supply connected by an electrician and tested to BS 7671
- Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
How much does cooker hood installation cost in Moray?
Typical cooker hood installation prices for homes in Moray, including VAT and adjusted for Scotland. Your own figure depends on the size of the kitchen, the layout and what is moving. Prices in Scotland usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Like-for-like cooker hood swapSame position and ducting | £110–£230 |
| New ducted hood through an outside wallCore drilling, ducting run and external grille | £280–£850 |
| Island or ceiling hood installedTwo-person install, fixings to the ceiling structure | £280–£590 |
| Recirculating hood fittedNo ducting; carbon filters need replacing | £110–£280 |
Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.
Kitchens in homes across Moray
You will find stone fishing cottages, Victorian villas, post-war council-built houses and farm cottages throughout Moray. Fishing cottages along the coast often have a small kitchen in a rear extension, while villas in Elgin and Forres tend to have larger separate kitchens.
Most of Moray has soft mains water, though some rural homes on private supplies may need testing and filtering for taste and safety. Rural roads, farm tracks and distances between towns can affect delivery vehicles, so worktop lengths and delivery times are planned at the survey.
Small rooms and thick walls usually shape the layout of a stone fishing cottage, and extraction needs careful planning. Rural homes are often off the gas grid, so the kitchen may be built around induction, LPG or an oil-fired range.
Rules for cooker hood installation in Moray
In Scotland, standard 3.14 of the domestic Technical Handbook expects kitchens to have extract ventilation, and a recirculating hood alone does not remove moisture. Fitting an extractor fan or a ducted hood does not normally need a building warrant. In a flat, a new vent through a shared outside wall may need the other owners' agreement and planning permission, and a listed building may need listed building consent. Where the room has an open-flued gas appliance, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.
Upland parts of Moray fall within the Cairngorms National Park, and listed buildings or conservation areas in older towns may need consent for new external vents.
Before you start
- For an island or ceiling hood, find out what is above the ceiling, as joists or added timbers are needed to carry the weight securely.
- Keep the duct run short and straight with rigid ducting, because every bend and extra metre of flexible hose reduces how much air the hood moves.
- Choose ducted extraction where you can; a recirculating hood filters grease and smells but leaves the moisture from cooking in the room.
- Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.
- For an island hood in your Moray kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
- If your Moray home is listed, or in a building with strict rules on outside changes, check what is allowed before any hole is cut for a duct.
Questions about cooker hood installation in Moray
How much does cooker hood installation cost in Moray?
Cooker hood installation in Moray typically costs £110 to £230 including VAT for a like-for-like cooker hood swap, based on prices in Scotland. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.
Do you cover the whole of Moray?
Yes. We carry out cooker hood installation across Moray, including Elgin, Forres and Buckie. Every job starts with a free survey visit and an itemised written quote.
Why might a cooker hood need a spillage test?
Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.
Does a cooker hood need a hole in the wall?
A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.
How high should a cooker hood be above the hob?
At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.
Cooker hood installation in towns across Moray
Choose a town for local guide prices and postcode coverage:
- Cooker hood installation in Elgin
- Cooker hood installation in Forres
- Cooker hood installation in Buckie