Cooker hood installation · Scotland
Cooker hood installation in Fife
Our cooker hood installation work covers the whole of Fife, including Dunfermline, Kirkcaldy and Glenrothes.
Why do people in Fife choose cooker hood installation?
If your Fife house has thick solid walls, core drilling a neat hole for the duct takes the right equipment and careful positioning of the outside grille.
Cooks across Fife who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead.
What does cooker hood installation in Fife include?
The exact scope is agreed after the survey, but a typical job in Fife covers:
- Survey of the hob position, duct route, outside wall and any open-flued appliance
- Hood fixed at the height set by the hood and hob manufacturers
- Core drilling through the outside wall and an external grille fitted and sealed
- Short, straight runs of rigid ducting wherever the route allows
- Island and ceiling hoods fixed into the ceiling structure by two people
- Recirculating hoods fitted with carbon filters, and their limits explained
- Power supply connected by an electrician and tested to BS 7671
- Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
How much does cooker hood installation cost in Fife?
Typical cooker hood installation prices for homes in Fife, including VAT and adjusted for Scotland. Your own figure depends on the size of the kitchen, the layout and what is moving. Labour rates in Scotland are generally lower than in London and the South East, so these ranges are a little below the national guide.
| Typical project | Guide price |
|---|---|
| Like-for-like cooker hood swapSame position and ducting | £110–£230 |
| New ducted hood through an outside wallCore drilling, ducting run and external grille | £280–£850 |
| Island or ceiling hood installedTwo-person install, fixings to the ceiling structure | £280–£590 |
| Recirculating hood fittedNo ducting; carbon filters need replacing | £110–£280 |
Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.
Kitchens in homes across Fife
You will find pantiled fishing cottages, sandstone tenement flats, post-war council-built houses and new-build estates throughout Fife. Fishing cottages in the coastal villages often have a tiny kitchen at the back, while ex-council houses and new-builds around Dunfermline and Glenrothes tend to have compact L-shaped rooms.
Fife's mains water is soft, so limescale is rarely a big concern and taps and boiling water taps tend to stay cleaner. Narrow coastal village streets with little parking can make deliveries tricky, while new-town estates usually have easier access for vans and long worktops.
Thick walls, low ceilings and small rooms usually shape the layout of a fishing cottage kitchen, and extraction needs careful thought. Newer homes around Glenrothes and Dunfermline more often need a straight replacement of the builder's original kitchen, with integrated appliances, more storage and better lighting.
Rules for cooker hood installation in Fife
In Scotland, standard 3.14 of the domestic Technical Handbook expects kitchens to have extract ventilation, and a recirculating hood alone does not remove moisture. Fitting an extractor fan or a ducted hood does not normally need a building warrant. In a flat, a new vent through a shared outside wall may need the other owners' agreement and planning permission, and a listed building may need listed building consent. Where the room has an open-flued gas appliance, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.
Listed cottages and conservation areas, including St Andrews and the East Neuk villages, may need consent for a new vent on a visible wall.
Before you start
- Choose ducted extraction where you can; a recirculating hood filters grease and smells but leaves the moisture from cooking in the room.
- Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.
- In a flat or a listed building, check what consents are needed before any hole is cut through an outside wall.
- Keep the duct run short and straight with rigid ducting, because every bend and extra metre of flexible hose reduces how much air the hood moves.
- Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
- Before choosing a hood for your Fife kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
Questions about cooker hood installation in Fife
How much does cooker hood installation cost in Fife?
Cooker hood installation in Fife typically costs £110 to £230 including VAT for a like-for-like cooker hood swap, based on prices in Scotland. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.
Do you cover the whole of Fife?
Yes. We carry out cooker hood installation across Fife, including Dunfermline, Kirkcaldy, Glenrothes and St Andrews. Every job starts with a free survey visit and an itemised written quote.
Should I choose a ducted or a recirculating cooker hood?
A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.
Does a cooker hood need a hole in the wall?
A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.
How high should a cooker hood be above the hob?
At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.
Cooker hood installation in towns across Fife
Choose a town for local guide prices and postcode coverage:
- Cooker hood installation in Dunfermline
- Cooker hood installation in Kirkcaldy
- Cooker hood installation in Glenrothes
- Cooker hood installation in St Andrews