Cooker hood installation in Dagenham

What prompts cooker hood installation in Dagenham?

Cooks across Greater London who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead.

Homeowners in Dagenham adding a hob to a new island often need a ceiling hood with solid fixings and a duct route planned before the ceiling is closed up. Homes right across Dagenham are covered, as are nearby places such as Romford, Hornchurch and the villages in between.

What we cover for cooker hood installation in Dagenham

After the survey visit we write the scope down. For cooker hood installation in Dagenham it usually covers:

Hood fixed at the height set by the hood and hob manufacturers
Recirculating hoods fitted with carbon filters, and their limits explained
Island and ceiling hoods fixed into the ceiling structure by two people
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Power supply connected by an electrician and tested to BS 7671
Survey of the hob position, duct route, outside wall and any open-flued appliance

What does cooker hood installation cost in Dagenham?

The figures below are guide prices for Dagenham, including VAT and adjusted for typical costs across London. The fixed price comes after we have measured up. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.

What does cooker hood installation cost in Dagenham?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£160–£310
New ducted hood through an outside wallCore drilling, ducting run and external grille	£390–£1,200
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£390–£820
Recirculating hood fittedNo ducting; carbon filters need replacing	£160–£390

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

What kind of kitchens do we fit in Dagenham?

Typical homes in this part of Greater London include Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

What rules apply to cooker hood installation in Dagenham?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Before you book cooker hood installation in Dagenham

Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
If your Dagenham home is listed, or in a building with strict rules on outside changes, check what is allowed before any hole is cut for a duct.
Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.

Questions about cooker hood installation in Dagenham

How much does cooker hood installation cost in Dagenham?

Cooker hood installation in Dagenham typically costs £160 to £310 including VAT for a like-for-like cooker hood swap, based on prices in London. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.

Do you work near Dagenham as well?

Yes. As well as Dagenham itself, we cover the rest of Greater London and nearby towns such as Romford and Hornchurch. The process is the same wherever the kitchen is.

How high should a cooker hood be above the hob?

At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

Cooker hood installation near Dagenham

The same service is available a short drive from Dagenham, including: