Kitchen Installers UK

Cooker hood installation · North Yorkshire

Cooker hood installation in Thornaby-on-Tees

Homeowners and landlords in Thornaby-on-Tees can book us for cooker hood installation: ducted and recirculating cooker hoods fitted, with wall core drilling, ducting and an external grille.

Guide price£110 to £860
Postcodes includeTS17
Timescale3 to 7 hours for most hoods
A fitter on a step ladder fixing a stainless steel chimney cooker hood above a hob, with ducting visible above

When does cooker hood installation make sense in Thornaby-on-Tees?

If your Thornaby-on-Tees kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.

People in flats across North Yorkshire sometimes rely on recirculating hoods because an outside vent needs consent from the building's owners, and want to know what else improves ventilation. Our North Yorkshire coverage reaches every part of Thornaby-on-Tees (TS17) and out towards Stockton-on-Tees.

What we cover for cooker hood installation in Thornaby-on-Tees

After the survey visit we write the scope down. For cooker hood installation in Thornaby-on-Tees it usually covers:

  • Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
  • Island and ceiling hoods fixed into the ceiling structure by two people
  • Core drilling through the outside wall and an external grille fitted and sealed
  • Survey of the hob position, duct route, outside wall and any open-flued appliance
  • Hood fixed at the height set by the hood and hob manufacturers
  • Short, straight runs of rigid ducting wherever the route allows

Cooker hood installation prices in Thornaby-on-Tees

Typical cooker hood installation prices for homes in Thornaby-on-Tees, including VAT and adjusted for Yorkshire and the Humber. Your own figure depends on the size of the kitchen, the layout and what is moving. Prices in Yorkshire and the Humber usually come in below the national guide, as labour rates are lower than in the South East.

Cooker hood installation prices in Thornaby-on-Tees
Typical projectGuide price
Like-for-like cooker hood swapSame position and ducting£110–£230
New ducted hood through an outside wallCore drilling, ducting run and external grille£280–£860
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure£280–£600
Recirculating hood fittedNo ducting; carbon filters need replacing£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

What kind of kitchens do we fit in Thornaby-on-Tees?

Across North Yorkshire you will often find stone-built cottages, Victorian terraces, Georgian townhouses and post-war semis, and each shapes the kitchen differently. Dales and moorland stone cottages often have a small kitchen in a rear extension, while terraces in York and Middlesbrough tend to have a narrow back galley.

Dales and moorland roads can be narrow and steep, and older streets in York can have restricted parking, so delivery vehicles and timing need planning. Water hardness varies across North Yorkshire, from soft in some upland areas to moderately hard elsewhere, so check with your supplier before choosing a filter.

Do you need approval for cooker hood installation in Thornaby-on-Tees?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Homes in the Yorkshire Dales or North York Moors national parks, York's many listed buildings and conservation areas may need consent for new vents or internal changes.

Practical advice for Thornaby-on-Tees homeowners

  • Check whether your Thornaby-on-Tees home has an open-flued boiler or gas fire, and mention it at the survey so a spillage test can be planned.
  • Before choosing a hood for your Thornaby-on-Tees kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
  • Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
  • For an island or ceiling hood, find out what is above the ceiling, as joists or added timbers are needed to carry the weight securely.

Questions about cooker hood installation in Thornaby-on-Tees

How much does cooker hood installation cost in Thornaby-on-Tees?

Guide prices in Thornaby-on-Tees are about £110 to £230 including VAT for a like-for-like cooker hood swap. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.

Can you measure up in Thornaby-on-Tees before quoting?

Yes. Every quote starts with a free, no-obligation survey visit to your home in Thornaby-on-Tees. We measure the room, check the walls, floor and service positions, then send an itemised written quote.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

Nearby places we cover

Close to Thornaby-on-Tees? We cover these nearby towns too:

Other kitchen work in Thornaby-on-Tees

Free survey visit

Book a free survey visit in Thornaby-on-Tees

We measure up, check walls, floors and service positions, and send an itemised written quote. Or get a guide price online in about two minutes.

Book a free survey visit

Tell us about the kitchen and the work. We will call to arrange a visit.

We use your details only to arrange your visit and quote. See our privacy notice.

Prefer to talk? 0800 088 6341

CallGuide price