Cooker hood installation in Selby

What prompts cooker hood installation in Selby?

If condensation runs down the windows of your Selby kitchen whenever you cook, the hood may be recirculating, undersized or ducted through a long, flexible run.

If your Selby house has thick solid walls, core drilling a neat hole for the duct takes the right equipment and careful positioning of the outside grille. Homes right across Selby are covered, as are nearby places such as Goole, Pontefract and the villages in between.

What is included in the work?

The exact scope is agreed after the survey, but a typical job in Selby covers:

Short, straight runs of rigid ducting wherever the route allows
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Core drilling through the outside wall and an external grille fitted and sealed
Survey of the hob position, duct route, outside wall and any open-flued appliance
Island and ceiling hoods fixed into the ceiling structure by two people
Hood fixed at the height set by the hood and hob manufacturers

Cooker hood installation prices in Selby

As a starting point for Selby, these ranges include VAT at 20% and allow for typical labour costs in Yorkshire and the Humber. Prices in Yorkshire and the Humber usually come in below the national guide, as labour rates are lower than in the South East.

Cooker hood installation prices in Selby
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£110–£230
New ducted hood through an outside wallCore drilling, ducting run and external grille	£280–£860
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£280–£600
Recirculating hood fittedNo ducting; carbon filters need replacing	£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Local homes and their kitchens

Typical homes in this part of North Yorkshire include stone-built cottages, Victorian terraces, Georgian townhouses and post-war semis. Dales and moorland stone cottages often have a small kitchen in a rear extension, while terraces in York and Middlesbrough tend to have a narrow back galley.

Water hardness varies across North Yorkshire, from soft in some upland areas to moderately hard elsewhere, so check with your supplier before choosing a filter. Dales and moorland roads can be narrow and steep, and older streets in York can have restricted parking, so delivery vehicles and timing need planning.

Do you need approval for cooker hood installation in Selby?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Homes in the Yorkshire Dales or North York Moors national parks, York's many listed buildings and conservation areas may need consent for new vents or internal changes.

Worth knowing before the fit

If you live in a flat in North Yorkshire, ask the freeholder, factor or managing agent about outside vents before you buy a ducted hood.
Before choosing a hood for your Selby kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.

Questions about cooker hood installation in Selby

How much does cooker hood installation cost in Selby?

Guide prices in Selby are about £110 to £230 including VAT for a like-for-like cooker hood swap. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.

Do you work near Selby as well?

Yes. As well as Selby itself, we cover the rest of North Yorkshire and nearby towns such as Goole and Pontefract. The process is the same wherever the kitchen is.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

Also covering nearby towns

Close to Selby? We cover these nearby towns too: