Cooker hood installation in Norbury

Thinking about cooker hood installation in Norbury?

If your Norbury kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.

Homeowners in Norbury adding a hob to a new island often need a ceiling hood with solid fixings and a duct route planned before the ceiling is closed up. Our Greater London coverage reaches every part of Norbury (SW16) and out towards Streatham.

What we cover for cooker hood installation in Norbury

Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:

Core drilling through the outside wall and an external grille fitted and sealed
Survey of the hob position, duct route, outside wall and any open-flued appliance
Power supply connected by an electrician and tested to BS 7671
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Hood fixed at the height set by the hood and hob manufacturers
Island and ceiling hoods fixed into the ceiling structure by two people

Guide prices for cooker hood installation in Norbury

These guide ranges include VAT at 20% and are adjusted for prices in London. We confirm your price in writing after a free survey visit. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.

Guide prices for cooker hood installation in Norbury
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£160–£310
New ducted hood through an outside wallCore drilling, ducting run and external grille	£390–£1,200
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£390–£820
Recirculating hood fittedNo ducting; carbon filters need replacing	£160–£390

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Kitchens in homes around Norbury

You will find Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis throughout Greater London. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

What rules apply to cooker hood installation in Norbury?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Worth knowing before the fit

For an island hood in your Norbury kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
Check whether your Norbury home has an open-flued boiler or gas fire, and mention it at the survey so a spillage test can be planned.
Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.

Questions about cooker hood installation in Norbury

How much does cooker hood installation cost in Norbury?

Cooker hood installation in Norbury typically costs £160 to £310 including VAT for a like-for-like cooker hood swap, based on prices in London. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.

Which parts of Norbury do you work in?

All of them. Our Greater London coverage takes in the whole of Norbury, including the SW16 postcode district, as well as surrounding towns such as Streatham. If you are unsure, send us your postcode.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Cooker hood installation in neighbouring towns

Close to Norbury? We cover these nearby towns too: