Cooker hood installation in Chelsea

Who usually needs cooker hood installation in Chelsea?

A new kitchen in a Chelsea home can move the hob away from the old vent, so the hood, the duct run and the wall grille all need rethinking together.

If your Chelsea kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test. We work throughout Chelsea (SW3 and SW10) and across the wider Greater London area.

What does cooker hood installation in Chelsea include?

Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:

Short, straight runs of rigid ducting wherever the route allows
Power supply connected by an electrician and tested to BS 7671
Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Recirculating hoods fitted with carbon filters, and their limits explained
Core drilling through the outside wall and an external grille fitted and sealed
Hood fixed at the height set by the hood and hob manufacturers

Cooker hood installation prices in Chelsea

The figures below are guide prices for Chelsea, including VAT and adjusted for typical costs across London. The fixed price comes after we have measured up. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.

Cooker hood installation prices in Chelsea
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£160–£310
New ducted hood through an outside wallCore drilling, ducting run and external grille	£390–£1,200
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£390–£820
Recirculating hood fittedNo ducting; carbon filters need replacing	£160–£390

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Fitting kitchens in older and newer Chelsea homes

In and around Chelsea, homes range across Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

What rules apply to cooker hood installation in Chelsea?

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Practical advice for Chelsea homeowners

For an island hood in your Chelsea kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
If your Chelsea home is listed, or in a building with strict rules on outside changes, check what is allowed before any hole is cut for a duct.
Check whether your Chelsea home has an open-flued boiler or gas fire, and mention it at the survey so a spillage test can be planned.
Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.

Questions about cooker hood installation in Chelsea

How much does cooker hood installation cost in Chelsea?

For a like-for-like cooker hood swap, budget around £160 to £310 including VAT in Chelsea. That reflects typical costs in London; we confirm the actual figure in writing once we have measured up.

Do you work near Chelsea as well?

Yes. As well as Chelsea itself, we cover the rest of Greater London and nearby towns such as Battersea and Fulham. The process is the same wherever the kitchen is.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Cooker hood installation in neighbouring towns

Close to Chelsea? We cover these nearby towns too: