Utility room fitting · Scotland
Utility room fitting in Lanarkshire
Utility room fitting in Lanarkshire starts with a free visit to measure up, then a written scope and quote before any work begins.
When does utility room fitting make sense in Lanarkshire?
If your Lanarkshire home has a back lobby or a rear porch with a little spare width, a few units and a stacked washer and dryer can make it a working utility.
Dog owners and keen walkers around Lanarkshire often ask for a utility with a deep sink, a coat cupboard and somewhere to leave muddy boots and wet jackets.
What does utility room fitting in Lanarkshire include?
Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:
- Free survey visit to check water, waste, power and outside wall positions
- Base, wall and tall units fitted, levelled and fixed to the wall
- Worktop over the washing machine and dryer, supported clear of the appliances
- Washing machine supply, waste and isolation valve, tested for leaks
- A vent to outside for a vented dryer, or a drain hose for condenser models
- Stacking kit fitted where the washer and dryer sit one above the other
- Utility sink and tap plumbed in, with new supplies and waste where none exist
- Extract fan fitted to clear moisture from washing and drying
How much does utility room fitting cost in Lanarkshire?
These guide ranges include VAT at 20% and are adjusted for prices in Scotland. We confirm your price in writing after a free survey visit. Prices in Scotland usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,100–£2,800 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £2,800–£6,600 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £380–£940 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Kitchens in homes across Lanarkshire
Across Lanarkshire you will often find sandstone tenement flats, four-in-a-block flats, new town houses and interwar council-built semis, and each shapes the kitchen differently. New-town houses in East Kilbride and Cumbernauld often have a compact galley, while tenement and four-in-a-block flats tend to have a small kitchen off the hall or at the back.
Lanarkshire's mains water is soft, so limescale is rarely an issue and taps, sinks and boiling water taps tend to stay cleaner. Common stairs in tenements and upper four-in-a-block flats mean units are carried by hand, while new-town estates may have parking courts some distance from the door.
Removing a partition between the kitchen and dining area is a common new-town project, subject to a building warrant if the wall is load-bearing. Ex-council semis often need a full strip-out with new wiring, more sockets and a layout that makes better use of the space by the back door.
Rules for utility room fitting in Lanarkshire
In Scotland, fitting utility units, plumbing in appliances and adding an extractor fan do not normally need a building warrant, but the electrics must meet the building standards and BS 7671, so ask for an Electrical Installation Certificate. A new connection to an underground drain, for example from a utility in a garage, needs a warrant first. Where an open-flued boiler is in the room, a Gas Safe registered engineer should check its flue with a spillage test after a fan is fitted.
The New Lanark World Heritage Site, other listed buildings and conservation areas may need consent for new vents, and flat owners may need neighbours' agreement.
Before you start
- If there is no water or waste in the space, new plumbing has to reach it, which is simplest close to an existing kitchen or bathroom.
- Stacking the dryer on the washing machine saves width, but it needs a stacking kit that suits both machines and enough height for the pair.
- Check which dryer you have: a vented dryer needs a duct to an outside wall, while condenser and heat pump dryers need emptying or a drain.
- Under-stairs spaces can take a washer and dryer, but check the headroom, the ventilation and room to pull machines out before committing.
- Before choosing a dryer for your Lanarkshire utility, check whether there is an outside wall close enough for a short, straight vent duct.
- Plan the sockets in your Lanarkshire utility so each appliance can be switched off at an accessible switch without moving the machine.
Questions about utility room fitting in Lanarkshire
How much does utility room fitting cost in Lanarkshire?
Guide prices in Lanarkshire are about £1,100 to £2,800 including VAT for fitting three to six utility units and a worktop you have bought. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.
Do you cover the whole of Lanarkshire?
Yes. We carry out utility room fitting across Lanarkshire, including East Kilbride, Hamilton, Cumbernauld and Coatbridge. Every job starts with a free survey visit and an itemised written quote.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Does a condenser or heat pump dryer need an outside vent?
No. Condenser and heat pump dryers do not need an outside vent, so they can go where a vented dryer cannot. They collect water in a container that has to be emptied, or they can be connected to the waste so they drain automatically, which is easy when the dryer sits beside the washing machine. They still give off some warmth, so the space needs air around it. A vented dryer needs a duct to an outside wall.
Can a utility room go in a garage or under the stairs?
Often, yes, as long as the space already exists and is usable. In a garage it needs to be dry and protected from frost, with power and a route for water and waste. Under the stairs, check the headroom, the ventilation and whether a door can open fully. We fit units and connect appliances in existing spaces; converting a garage into a habitable room is a separate building project.
Utility room fitting in towns across Lanarkshire
Choose a town for local guide prices and postcode coverage:
- Utility room fitting in East Kilbride
- Utility room fitting in Hamilton
- Utility room fitting in Cumbernauld
- Utility room fitting in Coatbridge
- Utility room fitting in Airdrie
- Utility room fitting in Motherwell
- Utility room fitting in Rutherglen
- Utility room fitting in Cambuslang
- Utility room fitting in Wishaw
- Utility room fitting in Bellshill
- Utility room fitting in Blantyre
- Utility room fitting in Viewpark
- Utility room fitting in Larkhall