Utility room fitting · Scotland
Utility room fitting in Glasgow
If you need utility room fitting anywhere in Glasgow, we survey the kitchen, agree the scope with you and book every trade through to handover.
Why utility room fitting for a Glasgow home?
Larger households in Glasgow sharing a lot of laundry often want a stacked washer and dryer, a hanging rail and a clear worktop for folding.
Dog owners and keen walkers around Glasgow often ask for a utility with a deep sink, a coat cupboard and somewhere to leave muddy boots and wet jackets.
What does utility room fitting in Glasgow include?
After the survey visit we write the scope down. For utility room fitting in Glasgow it usually covers:
- Free survey visit to check water, waste, power and outside wall positions
- Base, wall and tall units fitted, levelled and fixed to the wall
- Worktop over the washing machine and dryer, supported clear of the appliances
- Washing machine supply, waste and isolation valve, tested for leaks
- A vent to outside for a vented dryer, or a drain hose for condenser models
- Stacking kit fitted where the washer and dryer sit one above the other
- Utility sink and tap plumbed in, with new supplies and waste where none exist
- Extract fan fitted to clear moisture from washing and drying
How much does utility room fitting cost in Glasgow?
The figures below are guide prices for Glasgow, including VAT and adjusted for typical costs across Edinburgh and Glasgow. The fixed price comes after we have measured up. Costs in Edinburgh and Glasgow sit close to the national guide.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,200–£3,100 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £3,100–£7,100 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £410–£1,000 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Kitchens in homes across Glasgow
Across Glasgow you will often find sandstone tenement flats, Victorian terraces and villas, four-in-a-block flats and post-war high-rise flats, and each shapes the kitchen differently. Tenement flats often have a kitchen off the hall, sometimes with an old bed recess, while four-in-a-block flats tend to have a narrow galley at the back.
Glasgow's mains water is soft, much of it from Loch Katrine, so limescale is rarely a problem and taps and boiling water taps stay cleaner. Tenement closes and common stairs mean carrying units by hand, often to upper floors, and permit parking near the door may need arranging for delivery day.
Tenement kitchens often have high ceilings and a former bed recess, which can take tall units, a fridge freezer or a small dining nook. Four-in-a-block flats and ex-council houses more often need a full refit with new wiring, better storage and a more practical layout.
Rules for utility room fitting in Glasgow
In Scotland, fitting utility units, plumbing in appliances and adding an extractor fan do not normally need a building warrant, but the electrics must meet the building standards and BS 7671, so ask for an Electrical Installation Certificate. A new connection to an underground drain, for example from a utility in a garage, needs a warrant first. Where an open-flued boiler is in the room, a Gas Safe registered engineer should check its flue with a spillage test after a fan is fitted.
Many of the city's tenement streets, including much of the West End, are conservation areas, so a new external vent may need consent, and common walls involve neighbours.
Before you start
- Stacking the dryer on the washing machine saves width, but it needs a stacking kit that suits both machines and enough height for the pair.
- If there is no water or waste in the space, new plumbing has to reach it, which is simplest close to an existing kitchen or bathroom.
- Check which dryer you have: a vented dryer needs a duct to an outside wall, while condenser and heat pump dryers need emptying or a drain.
- A worktop over appliances needs support at each side and a gap above the machines, so they can be slid out for servicing.
- Ask for an isolation valve on the washing machine supply that can be reached without pulling the machine out from under the worktop.
- Leave room behind the washing machine for the hoses; pushing it hard against the wall can kink them and stop the water draining properly.
Questions about utility room fitting in Glasgow
How much does utility room fitting cost in Glasgow?
Utility room fitting in Glasgow typically costs £1,200 to £3,100 including VAT for fitting three to six utility units and a worktop you have bought, based on prices in Edinburgh and Glasgow. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.
Do you cover the whole of Glasgow?
Yes. We carry out utility room fitting across Glasgow. Every job starts with a free survey visit and an itemised written quote.
Does a condenser or heat pump dryer need an outside vent?
No. Condenser and heat pump dryers do not need an outside vent, so they can go where a vented dryer cannot. They collect water in a container that has to be emptied, or they can be connected to the waste so they drain automatically, which is easy when the dryer sits beside the washing machine. They still give off some warmth, so the space needs air around it. A vented dryer needs a duct to an outside wall.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Can a utility room go in a garage or under the stairs?
Often, yes, as long as the space already exists and is usable. In a garage it needs to be dry and protected from frost, with power and a route for water and waste. Under the stairs, check the headroom, the ventilation and whether a door can open fully. We fit units and connect appliances in existing spaces; converting a garage into a habitable room is a separate building project.