Utility room fitting · Northern Ireland
Utility room fitting in County Tyrone
Utility room fitting in County Tyrone starts with a free visit to measure up, then a written scope and quote before any work begins.
Thinking about utility room fitting in County Tyrone?
When a new kitchen is being planned in County Tyrone, moving the laundry to a utility often makes room for deep drawers or a dishwasher in the kitchen itself.
If your County Tyrone home has a back lobby or a rear porch with a little spare width, a few units and a stacked washer and dryer can make it a working utility.
What does utility room fitting in County Tyrone include?
Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:
- Free survey visit to check water, waste, power and outside wall positions
- Base, wall and tall units fitted, levelled and fixed to the wall
- Worktop over the washing machine and dryer, supported clear of the appliances
- Washing machine supply, waste and isolation valve, tested for leaks
- A vent to outside for a vented dryer, or a drain hose for condenser models
- Stacking kit fitted where the washer and dryer sit one above the other
- Utility sink and tap plumbed in, with new supplies and waste where none exist
- Extract fan fitted to clear moisture from washing and drying
How much does utility room fitting cost in County Tyrone?
The figures below are guide prices for County Tyrone, including VAT and adjusted for typical costs across Northern Ireland. The fixed price comes after we have measured up. Prices in Northern Ireland usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,100–£2,600 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £2,600–£6,200 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £350–£880 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Kitchens in homes across County Tyrone
Across County Tyrone you will often find rural bungalows, farmhouses, red-brick terraces and post-war estate houses, and each shapes the kitchen differently. Rural bungalows often have a long kitchen-dining room at the back, while terraced houses in Omagh and Strabane tend to have a narrow kitchen in the return.
Hardness varies across County Tyrone depending on the source, and some rural homes use private supplies, so check before choosing a filter or boiling water tap. Farm lanes, long drives and narrow country roads can limit delivery vehicles, so worktop lengths and delivery times are planned at the survey.
In a rural bungalow or farmhouse, the kitchen often doubles as the main living space, with a range, a large table and a utility for boots. Terraced houses in the towns tend to have small return kitchens that owners open into the living room.
Rules for utility room fitting in County Tyrone
In Northern Ireland, fitting a utility room in an existing space needs no planning permission or building control application. There is no notification scheme for domestic electrical work, but sockets and any new circuit should be installed and tested to BS 7671 and certified. New drainage connections go to council building control, Technical Booklet K covers ventilation, and a Gas Safe registered engineer should spillage-test any open-flued boiler after an extract fan is fitted.
A kitchen fit itself needs no planning permission, but listed buildings and homes in conservation areas in older town centres may need consent for new external vents.
Before you start
- A utility in a garage needs to be dry, lit and kept above freezing already; converting the garage itself is a separate building job.
- Under-stairs spaces can take a washer and dryer, but check the headroom, the ventilation and room to pull machines out before committing.
- Check which dryer you have: a vented dryer needs a duct to an outside wall, while condenser and heat pump dryers need emptying or a drain.
- If there is no water or waste in the space, new plumbing has to reach it, which is simplest close to an existing kitchen or bathroom.
- If your County Tyrone home has an open-flued boiler in the utility, ask for a spillage test by a Gas Safe registered engineer once an extract fan goes in.
- In a County Tyrone flat, check with the freeholder before a new dryer vent or extract fan is cut through an outside wall.
Questions about utility room fitting in County Tyrone
How much does utility room fitting cost in County Tyrone?
For fitting three to six utility units and a worktop you have bought, budget around £1,100 to £2,600 including VAT in County Tyrone. That reflects typical costs in Northern Ireland; we confirm the actual figure in writing once we have measured up.
Do you cover the whole of County Tyrone?
Yes. We carry out utility room fitting across County Tyrone, including Omagh, Strabane, Dungannon and Cookstown. Every job starts with a free survey visit and an itemised written quote.
Does a condenser or heat pump dryer need an outside vent?
No. Condenser and heat pump dryers do not need an outside vent, so they can go where a vented dryer cannot. They collect water in a container that has to be emptied, or they can be connected to the waste so they drain automatically, which is easy when the dryer sits beside the washing machine. They still give off some warmth, so the space needs air around it. A vented dryer needs a duct to an outside wall.
Can a worktop go over a washing machine and dryer?
Yes, and it is one of the most common utility layouts. The worktop is supported by units, end panels or a rail at each side rather than resting on the machines, with a small gap above them for vibration and so they can be slid out for servicing. Standard front-loading machines usually fit under a standard-height worktop, but we check the appliance heights against the plan first.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Utility room fitting in towns across County Tyrone
Choose a town for local guide prices and postcode coverage:
- Utility room fitting in Omagh
- Utility room fitting in Strabane
- Utility room fitting in Dungannon
- Utility room fitting in Cookstown