Splashbacks and tiling in Matlock

What prompts splashbacks and tiling in Matlock?

Some households in Derbyshire want tiling taken up to the ceiling behind a range cooker or open shelving, turning one whole wall into a practical feature that is easy to wipe down.

When a Matlock kitchen is getting stone worktops, upstands or a matching splashback are usually planned at the same time, so they are templated in one visit. Kitchens in every part of Matlock are covered, and the survey visit is free wherever you are in Derbyshire.

What does the job involve?

The exact scope is agreed after the survey, but a typical job in Matlock covers:

Old tiles removed and walls prepared, patched or boarded where needed
Stone upstands and splashbacks templated and fitted alongside a stone worktop
Full-height or feature tiling behind the hob, sink or open shelving
Toughened glass splashback measured after the worktops are fitted, with socket cut-outs
Free survey visit to check the walls, agree the layout and give an itemised quote
Tiled splashbacks between the worktop and wall units, set out from a centre line

What should you budget for splashbacks and tiling in Matlock?

Typical splashbacks and tiling prices for homes in Matlock, including VAT and adjusted for the East Midlands. Your own figure depends on the size of the kitchen, the layout and what is moving. For the East Midlands, these ranges are close to the national figures.

What should you budget for splashbacks and tiling in Matlock?
Typical project	Guide price
Tiled splashbackBetween worktop and wall units	£150–£390
Kitchen wall tiling, 4–6 m²Preparation, tiling and grouting	£290–£780
Toughened glass splashback behind the hob, fittedMade to measure after the worktops are in	£240–£580
Stone upstands and splashbacksTemplated with the worktop	Priced with the worktop

Tiling guide ranges cover preparation, adhesive, grout, trims and fixing, with the tiles themselves confirmed once chosen; the glass range includes a made-to-measure panel, and stone upstands are priced with the worktop. Prices include VAT at 20%.

Local homes and their kitchens

The housing mix across Derbyshire includes gritstone and limestone cottages, Victorian terraces, 1930s semis and former mining village terraces, so no two kitchen fits are quite alike. Terraces in Derby and Chesterfield often have a long galley behind the back room, while stone cottages in the Peak District may have a small kitchen in a rear extension.

Water hardness varies across Derbyshire, so check with your supplier; where it is harder, limescale on taps and boiling water taps is worth planning for. Steep hill villages and narrow lanes can limit delivery vehicles, while terraced streets in the towns may have little parking near the front door.

Regulations for kitchen work in Matlock

Tiling or fitting a splashback in England needs no planning permission or building regulations approval. If sockets or switches are moved to suit the new wall finish, that is electrical work to BS 7671; adding to an existing kitchen circuit is not notifiable under Part P, but a new circuit is. Behind a gas hob, follow the hob maker's clearance instructions, and in a listed building, removing historic tiles or panelling may need listed building consent.

Homes in the Peak District National Park, listed buildings and conservation areas may need consent for a new vent on a visible wall or alterations to historic features.

Before you book splashbacks and tiling in Matlock

Keep the tile boxes until the job is finished and note the batch number, so matching replacements can be found if a tile cracks later.
If your Derbyshire kitchen has a gas hob, check the hob instructions for splashback clearances before choosing glass or tiles for the wall behind it.
Ask to see where the tiling will start before the first row goes on in your Matlock kitchen, so narrow cut tiles end up in corners rather than on show.
Agree socket, switch and cooker hood positions before tiling starts; moving them afterwards means cutting tiles out and patching in replacements that may not match.

Questions about splashbacks and tiling in Matlock

How much do splashbacks and tiling cost in Matlock?

For a tiled splashback, budget around £150 to £390 including VAT in Matlock. That reflects typical costs in the East Midlands; we confirm the actual figure in writing once we have measured up.

Which parts of Matlock do you work in?

All of them. Our Derbyshire coverage takes in the whole of Matlock, including the DE4 postcode district, as well as surrounding towns such as Alfreton. If you are unsure, send us your postcode.

Which grout and sealant are easiest to keep clean?

A darker or mid-tone grout in narrow joints is usually the easiest to keep looking clean in a kitchen, and an epoxy or stain-resistant grout helps behind the hob and sink. Where the tiles meet the worktop, a flexible sealant is used rather than grout, because that joint moves slightly. The sealant can be cut out and renewed later without disturbing the tiles.

When are splashbacks fitted during a kitchen installation?

Splashbacks go on near the end, once the worktops are fixed and the electrician has agreed where the sockets and switches will sit. Tiles need a finished worktop to start from, glass is measured off the fitted worktop, and stone upstands are templated at the same visit as the worktop. Faceplates go back on after tiling, so the sockets sit neatly against the new finish.

Can a glass splashback go behind a gas hob?

Yes, usually, as long as the glass is toughened and the hob maker's instructions allow it. Toughened glass handles heat far better than ordinary glass, but a gas hob must still keep the clearances set out in its installation instructions, so we check those before ordering. The panel is measured after the worktops are fitted and made with cut-outs for sockets, because it cannot be cut once toughened.

Also covering nearby towns

Neighbouring towns where we offer splashbacks and tiling: