Splashbacks and tiling in Edmonton

When do splashbacks and tiling make sense in Edmonton?

If the kitchen in your Edmonton home is sound but the tiles are dated, cracked or stained, a new splashback is one of the simplest ways to refresh it without replacing units.

Homeowners in Edmonton often add a splashback as the final stage of a new kitchen, once the worktops are in and the bare wall above them needs a washable finish. Kitchens in every part of Edmonton are covered, and the survey visit is free wherever you are in Greater London.

What does the job involve?

After the survey visit we write the scope down. For splashbacks and tiling in Edmonton it usually covers:

Socket and switch plates refitted by an electrician once the tiling is finished
Grout and sealant chosen for easy cleaning, with flexible sealant at the worktop joint
Toughened glass splashback measured after the worktops are fitted, with socket cut-outs
Tiled splashbacks between the worktop and wall units, set out from a centre line
Stone upstands and splashbacks templated and fitted alongside a stone worktop
Old tiles removed and walls prepared, patched or boarded where needed

What do splashbacks and tiling cost in Edmonton?

The figures below are guide prices for Edmonton, including VAT and adjusted for typical costs across London. The fixed price comes after we have measured up. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.

What do splashbacks and tiling cost in Edmonton?
Typical project	Guide price
Tiled splashbackBetween worktop and wall units	£200–£520
Kitchen wall tiling, 4–6 m²Preparation, tiling and grouting	£390–£1,000
Toughened glass splashback behind the hob, fittedMade to measure after the worktops are in	£320–£780
Stone upstands and splashbacksTemplated with the worktop	Priced with the worktop

Tiling guide ranges cover preparation, adhesive, grout, trims and fixing, with the tiles themselves confirmed once chosen; the glass range includes a made-to-measure panel, and stone upstands are priced with the worktop. Prices include VAT at 20%.

What kind of kitchens do we fit in Edmonton?

Across Greater London you will often find Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis, and each shapes the kitchen differently. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

Building regulations, electrics and gas in Edmonton

Tiling or fitting a splashback in England needs no planning permission or building regulations approval. If sockets or switches are moved to suit the new wall finish, that is electrical work to BS 7671; adding to an existing kitchen circuit is not notifiable under Part P, but a new circuit is. Behind a gas hob, follow the hob maker's clearance instructions, and in a listed building, removing historic tiles or panelling may need listed building consent.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Getting the most from your splashbacks and tiling

Hold a few of your chosen tiles against the wall in your Edmonton kitchen, in daylight and under the kitchen lights, before ordering the full quantity.
If you are renting out a flat in Edmonton, a single glass panel or large plain tiles cut down the grout that needs cleaning at each check-out.
If your Greater London kitchen has a gas hob, check the hob instructions for splashback clearances before choosing glass or tiles for the wall behind it.
Heavy tiles, such as large porcelain or natural stone, may need a stronger backing board and a suitable adhesive, so have the wall checked first.

Questions about splashbacks and tiling in Edmonton

How much do splashbacks and tiling cost in Edmonton?

Guide prices in Edmonton are about £200 to £520 including VAT for a tiled splashback. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.

Can you measure up in Edmonton before quoting?

Yes. Every quote starts with a free, no-obligation survey visit to your home in Edmonton. We measure the room, check the walls, floor and service positions, then send an itemised written quote.

Can you tile over existing kitchen tiles?

Sometimes, but it is rarely the better choice in a kitchen. Tiling over old tiles adds thickness, so sockets, switches and the edge against the wall units may no longer line up, and the new tiles rely on the old ones staying firmly bonded. If the existing tiles are sound and flat it can work for a small area; otherwise we remove them and prepare the wall.

Which grout and sealant are easiest to keep clean?

A darker or mid-tone grout in narrow joints is usually the easiest to keep looking clean in a kitchen, and an epoxy or stain-resistant grout helps behind the hob and sink. Where the tiles meet the worktop, a flexible sealant is used rather than grout, because that joint moves slightly. The sealant can be cut out and renewed later without disturbing the tiles.

When are splashbacks fitted during a kitchen installation?

Splashbacks go on near the end, once the worktops are fixed and the electrician has agreed where the sockets and switches will sit. Tiles need a finished worktop to start from, glass is measured off the fitted worktop, and stone upstands are templated at the same visit as the worktop. Faceplates go back on after tiling, so the sockets sit neatly against the new finish.

Nearby places we cover

Close to Edmonton? We cover these nearby towns too: