Sink and tap installation · Greater London
Sink and tap installation in Brixton
We take on sink and tap installation in Brixton and the surrounding SW2 postcodes, working to a written scope so you know exactly what is included before anyone starts.
Who usually needs sink and tap installation in Brixton?
If a new dishwasher or washing machine is going next to the sink in your Brixton home, the trap and waste connections usually need changing as well.
Landlords in Greater London often swap tired sinks and taps between tenancies, choosing hard-wearing finishes and accessible valves so that later repairs are quick and cheap. Brixton sits about 3 miles south-east of Westminster, and our Greater London coverage takes in everything in between.
What is in a typical job?
Every kitchen is different, so we confirm the scope in writing. Most jobs of this kind include:
- Waste, overflow and trap fitted, with dishwasher and washing machine waste connections
- New sink fitted, sealed and connected to the existing supplies and waste
- Sink moved to a new position with new supply and waste runs
- Boiling water tap fitted with its tank, filter and power supply in the cupboard
- Isolation valves on the hot and cold supplies, with flexible tap tails connected
- Every joint leak tested, with water flow and drainage checked before handover
How much does sink and tap installation cost in Brixton?
The figures below are guide prices for Brixton, including VAT and adjusted for typical costs across London. The fixed price comes after we have measured up. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.
| Typical project | Guide price |
|---|---|
| Sink and tap plumbed inIsolation valves, waste and trap | £260–£520 |
| Boiling water tap installedTank under the sink, filter and power supply | £200–£460 |
| Sink moved to a new positionNew supplies and waste run | £520–£1,300 |
| Undermount sink in a stone worktopCut-out and polishing are done by the stone fabricator | Priced with the worktop |
Guide ranges cover labour and fittings such as valves, tails and wastes; the sink and tap themselves are extra, and undermount cut-outs in stone are priced with the worktop by the fabricator. Prices include VAT at 20%.
Fitting kitchens in older and newer Brixton homes
In and around Brixton, homes range across Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.
Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.
Building regulations, electrics and gas in Brixton
Replacing a sink and tap needs no approval in England, but the plumbing should meet the Water Supply (Water Fittings) Regulations 1999, including isolation valves and backflow protection. Connecting to an existing waste is routine, while a new connection to an underground drain involves building control. A new spur for a boiling water tap on an existing kitchen circuit is not notifiable under Part P, but it must meet BS 7671.
Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.
Practical advice for Brixton homeowners
- Ask for the dishwasher and washing machine hoses to be routed so they cannot kink behind the units once the appliances are pushed back into place.
- Find the stopcock in your Brixton home before the plumber arrives and check it turns off fully, as older stopcocks can stick or let water past.
- Ask whether a boiling water tap for your kitchen in Greater London needs a filter, how often it should be changed and where it will sit in the cupboard.
- Keep isolation valves reachable under the sink, so the tap can be serviced or a leak stopped without turning off the whole house supply.
Questions about sink and tap installation in Brixton
How much does sink and tap installation cost in Brixton?
Sink and tap installation in Brixton typically costs £260 to £520 including VAT for plumbing in a new sink and tap, based on prices in London. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.
Can you measure up in Brixton before quoting?
Yes. Every quote starts with a free, no-obligation survey visit to your home in Brixton. We measure the room, check the walls, floor and service positions, then send an itemised written quote.
Do I need isolation valves under my kitchen sink?
They are strongly advised, and we fit them as standard. An isolation valve on each supply to the tap, and on each appliance supply, lets you turn off the water to one fitting without shutting off the whole house. That makes changing a tap cartridge or dealing with a leak far simpler. The valves are left where they can still be reached once the cupboard is in use.
What is the difference between an inset and an undermount sink?
An inset sink drops into a cut-out from above, with its rim resting on the worktop, and suits laminate, wood and stone. An undermount sink is fixed beneath the worktop so the edge of the cut-out is exposed, which usually calls for a solid, water-resistant material such as stone or solid surface. Undermount cut-outs in stone are cut and polished by the fabricator.
What do I need for a boiling water tap?
A boiling water tap needs a tank in the cupboard under the sink, usually a socket or fused spur to power it, and often a filter, particularly where the water is hard. Some models have a minimum water pressure, so check yours before buying. The tap also needs a correctly sized hole in the sink or worktop and enough clear cupboard space for the tank and pipework.
Sink and tap installation in neighbouring towns
Close to Brixton? We cover these nearby towns too:
- Sink and tap installation in Peckham
- Sink and tap installation in Pimlico
- Sink and tap installation in Battersea
- Sink and tap installation in Westminster
- Sink and tap installation in Streatham
- Sink and tap installation in New Cross
- Sink and tap installation across Greater London