Cooker hood installation in Wrexham

Thinking about cooker hood installation in Wrexham?

If your Wrexham kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.

Homeowners in Wrexham adding a hob to a new island often need a ceiling hood with solid fixings and a duct route planned before the ceiling is closed up. Kitchens in every part of Wrexham are covered, and the survey visit is free wherever you are in Clwyd.

What we cover for cooker hood installation in Wrexham

The exact scope is agreed after the survey, but a typical job in Wrexham covers:

Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Short, straight runs of rigid ducting wherever the route allows
Power supply connected by an electrician and tested to BS 7671
Survey of the hob position, duct route, outside wall and any open-flued appliance
Hood fixed at the height set by the hood and hob manufacturers
Recirculating hoods fitted with carbon filters, and their limits explained

Guide prices for cooker hood installation in Wrexham

The figures below are guide prices for Wrexham, including VAT and adjusted for typical costs across Wales. The fixed price comes after we have measured up. Prices in Wales usually come in below the national guide, as labour rates are lower than in the South East.

Guide prices for cooker hood installation in Wrexham
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£110–£220
New ducted hood through an outside wallCore drilling, ducting run and external grille	£280–£830
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£280–£580
Recirculating hood fittedNo ducting; carbon filters need replacing	£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

Local homes and their kitchens

Typical homes in this part of Clwyd include Victorian terraces, stone cottages, seaside bungalows and post-war council-built houses. Terraced houses in Wrexham and Rhyl often have a narrow back kitchen, while bungalows along the coast tend to have a compact square kitchen.

Hardness varies across Clwyd, so check with your supplier; where water is softer, taps and boiling water taps suffer much less limescale. Hill villages, farm tracks and coastal flats without lifts can complicate deliveries, so the route for long worktops is checked when the kitchen is surveyed.

What rules apply to cooker hood installation in Wrexham?

Wales has its own Approved Document F with the same broad rates: about 30 litres per second from a hood extracting outside, or 60 litres per second from a fan elsewhere. A recirculating hood does not remove moisture. Extending a kitchen circuit to power a hood is notifiable under Part P in Wales, and a new vent through the outside wall of a flat may need planning permission and the freeholder's consent.

A straightforward kitchen fit needs no planning permission, though listed buildings and conservation areas in older towns and villages may need consent for a new external vent.

Before you book cooker hood installation in Wrexham

Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
If your Wrexham home is listed, or in a building with strict rules on outside changes, check what is allowed before any hole is cut for a duct.
If you live in a flat in Clwyd, ask the freeholder, factor or managing agent about outside vents before you buy a ducted hood.
For an island or ceiling hood, find out what is above the ceiling, as joists or added timbers are needed to carry the weight securely.

Questions about cooker hood installation in Wrexham

How much does cooker hood installation cost in Wrexham?

For a like-for-like cooker hood swap, budget around £110 to £220 including VAT in Wrexham. That reflects typical costs in Wales; we confirm the actual figure in writing once we have measured up.

Which parts of Wrexham do you work in?

All of them. Our Clwyd coverage takes in the whole of Wrexham, including the LL13 postcode district, as well as surrounding towns such as Rhosllannerchrugog. If you are unsure, send us your postcode.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

How high should a cooker hood be above the hob?

At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.

Should I choose a ducted or a recirculating cooker hood?

A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.

Nearby places we cover

The same service is available a short drive from Wrexham, including: