Cooker hood installation in Swansea

Is cooker hood installation right for your Swansea kitchen?

If your Swansea kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.

Cooks across West Glamorgan who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead. We cover all of Swansea, including the SA1 postcode district, and travel out to neighbouring towns across West Glamorgan.

What does the job involve?

Here is what usually goes into cooker hood installation, adjusted to your Swansea kitchen after we have measured it:

Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Island and ceiling hoods fixed into the ceiling structure by two people
Power supply connected by an electrician and tested to BS 7671
Survey of the hob position, duct route, outside wall and any open-flued appliance
Core drilling through the outside wall and an external grille fitted and sealed
Hood fixed at the height set by the hood and hob manufacturers

What should you budget for cooker hood installation in Swansea?

Use these ranges to plan your budget. They include VAT, reflect costs in Wales, and are firmed up once we have seen your Swansea kitchen. Labour rates in Wales are generally lower than in London and the South East, so these ranges are a little below the national guide.

What should you budget for cooker hood installation in Swansea?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£110–£220
New ducted hood through an outside wallCore drilling, ducting run and external grille	£280–£830
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£280–£580
Recirculating hood fittedNo ducting; carbon filters need replacing	£110–£280

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

House types around Swansea and what they mean for a kitchen

The housing mix across West Glamorgan includes Victorian terraces, valley terraces, post-war council-built houses and seaside bungalows, so no two kitchen fits are quite alike. Terraced houses in Swansea and Neath often have a narrow back kitchen, while post-war homes and bungalows tend to have a compact room that suits an L-shaped layout.

Steep hillside streets and terraces with steps to the door can make carrying worktops harder, so the delivery route is planned at the survey. Mains water in West Glamorgan is generally soft, so limescale is less of a worry and taps and boiling water taps tend to stay cleaner.

Do you need approval for cooker hood installation in Swansea?

Wales has its own Approved Document F with the same broad rates: about 30 litres per second from a hood extracting outside, or 60 litres per second from a fan elsewhere. A recirculating hood does not remove moisture. Extending a kitchen circuit to power a hood is notifiable under Part P in Wales, and a new vent through the outside wall of a flat may need planning permission and the freeholder's consent.

If your home is listed or in a conservation area, including parts of Swansea and some Gower villages, a new external vent or changes to historic features may need consent.

Practical advice for Swansea homeowners

Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
Check whether your Swansea home has an open-flued boiler or gas fire, and mention it at the survey so a spillage test can be planned.
Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.

Questions about cooker hood installation in Swansea

How much does cooker hood installation cost in Swansea?

Cooker hood installation in Swansea typically costs £110 to £220 including VAT for a like-for-like cooker hood swap, based on prices in Wales. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.

Can you measure up in Swansea before quoting?

Yes. Every quote starts with a free, no-obligation survey visit to your home in Swansea. We measure the room, check the walls, floor and service positions, then send an itemised written quote.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Why might a cooker hood need a spillage test?

Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

Nearby places we cover

Neighbouring towns where we offer cooker hood installation: