Cooker hood installation · Wales
Cooker hood installation in Mid Glamorgan
Cooker hood installation in Mid Glamorgan starts with a free visit to measure up, then a written scope and quote before any work begins.
Why cooker hood installation for a Mid Glamorgan home?
If your Mid Glamorgan kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.
A new kitchen in a Mid Glamorgan home can move the hob away from the old vent, so the hood, the duct run and the wall grille all need rethinking together.
What does cooker hood installation in Mid Glamorgan include?
After the survey visit we write the scope down. For cooker hood installation in Mid Glamorgan it usually covers:
- Survey of the hob position, duct route, outside wall and any open-flued appliance
- Hood fixed at the height set by the hood and hob manufacturers
- Core drilling through the outside wall and an external grille fitted and sealed
- Short, straight runs of rigid ducting wherever the route allows
- Island and ceiling hoods fixed into the ceiling structure by two people
- Recirculating hoods fitted with carbon filters, and their limits explained
- Power supply connected by an electrician and tested to BS 7671
- Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
How much does cooker hood installation cost in Mid Glamorgan?
Typical cooker hood installation prices for homes in Mid Glamorgan, including VAT and adjusted for Wales. Your own figure depends on the size of the kitchen, the layout and what is moving. Prices in Wales usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Like-for-like cooker hood swapSame position and ducting | £110–£220 |
| New ducted hood through an outside wallCore drilling, ducting run and external grille | £280–£830 |
| Island or ceiling hood installedTwo-person install, fixings to the ceiling structure | £280–£580 |
| Recirculating hood fittedNo ducting; carbon filters need replacing | £110–£280 |
Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.
Kitchens in homes across Mid Glamorgan
The housing mix across Mid Glamorgan includes valley terraces, post-war council-built houses, seaside bungalows and new-build estates, so no two kitchen fits are quite alike. Valley terraces often have a narrow kitchen in a rear extension, while post-war houses in towns such as Bridgend tend to have a compact room beside the dining area.
Soft water is usual across Mid Glamorgan, so limescale is less of a concern and taps and boiling water taps tend to stay cleaner. Steep valley streets and terraces built into hillsides can mean steps, tight turns and limited parking, so carrying long worktops is planned at the survey.
Many valley terraces have a long, narrow kitchen in the back extension, and owners often open it into the middle room for a kitchen-diner. Ex-council houses may need a full strip-out with new wiring, which is notifiable work.
Rules for cooker hood installation in Mid Glamorgan
Wales has its own Approved Document F with the same broad rates: about 30 litres per second from a hood extracting outside, or 60 litres per second from a fan elsewhere. A recirculating hood does not remove moisture. Extending a kitchen circuit to power a hood is notifiable under Part P in Wales, and a new vent through the outside wall of a flat may need planning permission and the freeholder's consent.
The northern fringe of the area falls within Bannau Brycheiniog National Park, and listed buildings or conservation areas may need consent for new external vents.
Before you start
- Choose ducted extraction where you can; a recirculating hood filters grease and smells but leaves the moisture from cooking in the room.
- In a flat or a listed building, check what consents are needed before any hole is cut through an outside wall.
- If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.
- Check the minimum height above the hob in both the hood and hob instructions, and use the greater of the two figures.
- Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
- Before choosing a hood for your Mid Glamorgan kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
Questions about cooker hood installation in Mid Glamorgan
How much does cooker hood installation cost in Mid Glamorgan?
For a like-for-like cooker hood swap, budget around £110 to £220 including VAT in Mid Glamorgan. That reflects typical costs in Wales; we confirm the actual figure in writing once we have measured up.
Do you cover the whole of Mid Glamorgan?
Yes. We carry out cooker hood installation across Mid Glamorgan, including Rhondda, Tonypandy, Bridgend and Merthyr Tydfil. Every job starts with a free survey visit and an itemised written quote.
How high should a cooker hood be above the hob?
At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.
Why might a cooker hood need a spillage test?
Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.
Should I choose a ducted or a recirculating cooker hood?
A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.
Cooker hood installation in towns across Mid Glamorgan
Choose a town for local guide prices and postcode coverage:
- Cooker hood installation in Rhondda
- Cooker hood installation in Tonypandy
- Cooker hood installation in Bridgend
- Cooker hood installation in Merthyr Tydfil
- Cooker hood installation in Pontypridd
- Cooker hood installation in Aberdare
- Cooker hood installation in Maesteg
- Cooker hood installation in Porthcawl