Utility room fitting · West Midlands
Utility room fitting in Stourbridge
From the survey to handover, utility room fitting in Stourbridge is run by us as one job, with the fitters and trades booked in the right order.

Thinking about utility room fitting in Stourbridge?
Larger households in Stourbridge sharing a lot of laundry often want a stacked washer and dryer, a hanging rail and a clear worktop for folding.
Dog owners and keen walkers around Stourbridge often ask for a utility with a deep sink, a coat cupboard and somewhere to leave muddy boots and wet jackets. If your home is in Stourbridge or close by in Brierley Hill or Kingswinford, the same survey, quote and fitting process applies.
What is in a typical job?
Your written quote lists everything included. For utility room fitting, that normally means:
- A vent to outside for a vented dryer, or a drain hose for condenser models
- Extract fan fitted to clear moisture from washing and drying
- Worktop over the washing machine and dryer, supported clear of the appliances
- Base, wall and tall units fitted, levelled and fixed to the wall
- Stacking kit fitted where the washer and dryer sit one above the other
- Free survey visit to check water, waste, power and outside wall positions
What does utility room fitting cost in Stourbridge?
The figures below are guide prices for Stourbridge, including VAT and adjusted for typical costs across the West Midlands. The fixed price comes after we have measured up. For the West Midlands, these ranges are close to the national figures.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,200–£3,000 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £3,000–£7,000 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £400–£1,000 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Fitting kitchens in older and newer Stourbridge homes
Across the West Midlands you will often find Victorian terraces, 1930s semis, post-war council-built houses and post-war flats and maisonettes, and each shapes the kitchen differently. Victorian terraces often have a long galley behind the back room, while 1930s semis across Birmingham and the Black Country tend to have a small kitchen at the rear.
Busy terraced streets, permit parking near town centres and blocks with shared lifts can each affect delivery times and how worktops reach the kitchen. Birmingham's water is relatively soft, while much of the Black Country and Coventry is harder, so check your supplier's hardness figure before choosing a filter.
Building regulations, electrics and gas in Stourbridge
Fitting a utility room needs no planning permission in England, though a new dryer vent through the outside wall of a flat may need planning permission and the freeholder's consent. Adding sockets to an existing circuit is not notifiable, but a new circuit is, under Part P. Approved Document F sets an extract rate of about 30 litres per second for a utility room, so a new fan should be sized to meet it, and if an open-flued boiler shares the room, a Gas Safe registered engineer should carry out a spillage test once a fan is fitted.
Conservation areas and listed buildings, including parts of Birmingham and Solihull, may need consent for new vents, and flat owners usually need the freeholder's consent first.
Before you book utility room fitting in Stourbridge
- If your West Midlands home has an open-flued boiler in the utility, ask for a spillage test by a Gas Safe registered engineer once an extract fan goes in.
- If the utility will be in the garage of your Stourbridge home, make sure the space stays above freezing in winter for the pipes and machines.
- Before choosing a dryer for your Stourbridge utility, check whether there is an outside wall close enough for a short, straight vent duct.
- Under-stairs spaces can take a washer and dryer, but check the headroom, the ventilation and room to pull machines out before committing.
Questions about utility room fitting in Stourbridge
How much does utility room fitting cost in Stourbridge?
Guide prices in Stourbridge are about £1,200 to £3,000 including VAT for fitting three to six utility units and a worktop you have bought. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.
Can you measure up in Stourbridge before quoting?
Yes. Every quote starts with a free, no-obligation survey visit to your home in Stourbridge. We measure the room, check the walls, floor and service positions, then send an itemised written quote.
Can a utility room go in a garage or under the stairs?
Often, yes, as long as the space already exists and is usable. In a garage it needs to be dry and protected from frost, with power and a route for water and waste. Under the stairs, check the headroom, the ventilation and whether a door can open fully. We fit units and connect appliances in existing spaces; converting a garage into a habitable room is a separate building project.
Does a condenser or heat pump dryer need an outside vent?
No. Condenser and heat pump dryers do not need an outside vent, so they can go where a vented dryer cannot. They collect water in a container that has to be emptied, or they can be connected to the waste so they drain automatically, which is easy when the dryer sits beside the washing machine. They still give off some warmth, so the space needs air around it. A vented dryer needs a duct to an outside wall.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Utility room fitting in neighbouring towns
Neighbouring towns where we offer utility room fitting:
- Utility room fitting in Brierley Hill
- Utility room fitting in Kingswinford
- Utility room fitting in Dudley
- Utility room fitting in Halesowen
- Utility room fitting in Tipton
- Utility room fitting in Kidderminster
- Utility room fitting across the West Midlands
