Utility room fitting · Scotland
Utility room fitting in Edinburgh
We carry out utility room fitting across Edinburgh, from the city centre to the suburbs, with a free survey visit and an itemised written quote as standard.
What prompts utility room fitting in Edinburgh?
In an Edinburgh house where the garage is already used for storage rather than the car, some people fit a run of units and the laundry along one wall.
Landlords letting larger family homes across Edinburgh sometimes add a utility so tenants have room for laundry, coats and cleaning kit without filling the kitchen with appliances.
What does utility room fitting in Edinburgh include?
After the survey visit we write the scope down. For utility room fitting in Edinburgh it usually covers:
- Free survey visit to check water, waste, power and outside wall positions
- Base, wall and tall units fitted, levelled and fixed to the wall
- Worktop over the washing machine and dryer, supported clear of the appliances
- Washing machine supply, waste and isolation valve, tested for leaks
- A vent to outside for a vented dryer, or a drain hose for condenser models
- Stacking kit fitted where the washer and dryer sit one above the other
- Utility sink and tap plumbed in, with new supplies and waste where none exist
- Extract fan fitted to clear moisture from washing and drying
How much does utility room fitting cost in Edinburgh?
These guide ranges include VAT at 20% and are adjusted for prices in Edinburgh and Glasgow. We confirm your price in writing after a free survey visit. For Edinburgh and Glasgow, these ranges are close to the national figures.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,200–£3,100 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £3,100–£7,100 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £410–£1,000 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Kitchens in homes across Edinburgh
Across Edinburgh you will often find Victorian tenement flats, Georgian New Town flats, stone villas and post-war council-built houses, and each shapes the kitchen differently. Tenement flats often have a small kitchen off the hall, while Georgian flats may have kitchens in former bedrooms or reception rooms with tall ceilings.
Edinburgh's mains water is soft, so limescale is rarely a problem and taps, sinks and boiling water taps stay cleaner for longer. Common stairs without lifts, controlled parking and cobbled streets in older parts of the city mean deliveries and stair carries need planning before fitting day.
Tenement and Georgian flats often have kitchens in small rooms, and opening one into the living room needs a building warrant if the wall is load-bearing, and can need one even if it is not, where the change affects the escape route or fire separation in a flat. Stone villas and bungalows on the edge of the city more often suit a larger supply-and-fit kitchen.
Rules for utility room fitting in Edinburgh
In Scotland, fitting utility units, plumbing in appliances and adding an extractor fan do not normally need a building warrant, but the electrics must meet the building standards and BS 7671, so ask for an Electrical Installation Certificate. A new connection to an underground drain, for example from a utility in a garage, needs a warrant first. Where an open-flued boiler is in the room, a Gas Safe registered engineer should check its flue with a spillage test after a fan is fitted.
The Old and New Towns form a World Heritage Site with many listed buildings, so new vents or internal changes may need consent, and tenement neighbours may need to agree.
Before you start
- A worktop over appliances needs support at each side and a gap above the machines, so they can be slid out for servicing.
- If there is no water or waste in the space, new plumbing has to reach it, which is simplest close to an existing kitchen or bathroom.
- Check which dryer you have: a vented dryer needs a duct to an outside wall, while condenser and heat pump dryers need emptying or a drain.
- Stacking the dryer on the washing machine saves width, but it needs a stacking kit that suits both machines and enough height for the pair.
- Measure the washer and dryer heights, including any stacking kit, before ordering wall units or shelves to go above them.
- Before choosing a dryer for your Edinburgh utility, check whether there is an outside wall close enough for a short, straight vent duct.
Questions about utility room fitting in Edinburgh
How much does utility room fitting cost in Edinburgh?
For fitting three to six utility units and a worktop you have bought, budget around £1,200 to £3,100 including VAT in Edinburgh. That reflects typical costs in Edinburgh and Glasgow; we confirm the actual figure in writing once we have measured up.
Do you cover the whole of Edinburgh?
Yes. We carry out utility room fitting across Edinburgh. Every job starts with a free survey visit and an itemised written quote.
Can a worktop go over a washing machine and dryer?
Yes, and it is one of the most common utility layouts. The worktop is supported by units, end panels or a rail at each side rather than resting on the machines, with a small gap above them for vibration and so they can be slid out for servicing. Standard front-loading machines usually fit under a standard-height worktop, but we check the appliance heights against the plan first.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Can a utility room go in a garage or under the stairs?
Often, yes, as long as the space already exists and is usable. In a garage it needs to be dry and protected from frost, with power and a route for water and waste. Under the stairs, check the headroom, the ventilation and whether a door can open fully. We fit units and connect appliances in existing spaces; converting a garage into a habitable room is a separate building project.