Utility room fitting · County Antrim
Utility room fitting in Carrickfergus
If you live in Carrickfergus and need utility room fitting, we can measure the room, send an itemised written quote and book every trade in the right order until the kitchen is handed over.

Who usually needs utility room fitting in Carrickfergus?
If your Carrickfergus home has a back lobby or a rear porch with a little spare width, a few units and a stacked washer and dryer can make it a working utility.
In a Carrickfergus house where the garage is already used for storage rather than the car, some people fit a run of units and the laundry along one wall. Carrickfergus sits about 10 miles north-east of Belfast, and our County Antrim coverage takes in everything in between.
What does utility room fitting in Carrickfergus include?
After the survey visit we write the scope down. For utility room fitting in Carrickfergus it usually covers:
- Free survey visit to check water, waste, power and outside wall positions
- Utility sink and tap plumbed in, with new supplies and waste where none exist
- Stacking kit fitted where the washer and dryer sit one above the other
- Worktop over the washing machine and dryer, supported clear of the appliances
- Extract fan fitted to clear moisture from washing and drying
- A vent to outside for a vented dryer, or a drain hose for condenser models
What does utility room fitting cost in Carrickfergus?
The figures below are guide prices for Carrickfergus, including VAT and adjusted for typical costs across Northern Ireland. The fixed price comes after we have measured up. Prices in Northern Ireland usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Utility units and worktop fitted (fit only)Three to six units, laminate worktop, panels | £1,100–£2,600 |
| Utility room supplied and fittedUnits, worktop, sink, washer and dryer connections | £2,600–£6,200 |
| New utility plumbing for a sink and washing machineSupplies, waste and valves where none exist | £350–£880 |
Fit-only and supply-and-fit ranges cover units, worktop and standard sink and appliance connections, with new plumbing where none exists as a separate line; extract fans, dryer vents and new circuits are quoted on top. Prices include VAT at 20%.
Fitting kitchens in older and newer Carrickfergus homes
Typical homes in this part of County Antrim include red-brick terraces, Victorian villas, post-war estate houses and rural bungalows. Red-brick terraces in Belfast often have a narrow kitchen in the return, while estate houses and rural bungalows tend to have a separate kitchen with room for a table.
Mains water across most of County Antrim is soft, so limescale is less of a problem and taps and boiling water taps tend to stay cleaner. Terraced streets with entries at the back, city flats with booked lifts and country lanes can each affect deliveries, so the route for worktops is checked at the survey.
What rules apply to utility room fitting in Carrickfergus?
In Northern Ireland, fitting a utility room in an existing space needs no planning permission or building control application. There is no notification scheme for domestic electrical work, but sockets and any new circuit should be installed and tested to BS 7671 and certified. New drainage connections go to council building control, Technical Booklet K covers ventilation, and a Gas Safe registered engineer should spillage-test any open-flued boiler after an extract fan is fitted.
Listed buildings and conservation areas in older parts of Belfast and the county towns may need consent for new vents, and apartment owners usually need management consent.
Worth knowing before the fit
- Ask for an isolation valve on the washing machine supply that can be reached without pulling the machine out from under the worktop.
- If the utility will be in the garage of your Carrickfergus home, make sure the space stays above freezing in winter for the pipes and machines.
- Plan the sockets in your Carrickfergus utility so each appliance can be switched off at an accessible switch without moving the machine.
- Check which dryer you have: a vented dryer needs a duct to an outside wall, while condenser and heat pump dryers need emptying or a drain.
Questions about utility room fitting in Carrickfergus
How much does utility room fitting cost in Carrickfergus?
Guide prices in Carrickfergus are about £1,100 to £2,600 including VAT for fitting three to six utility units and a worktop you have bought. The final price depends on the size of the kitchen and what is moving, and is set out in an itemised written quote.
Can you measure up in Carrickfergus before quoting?
Yes. Every quote starts with a free, no-obligation survey visit to your home in Carrickfergus. We measure the room, check the walls, floor and service positions, then send an itemised written quote.
Can a utility room go in a garage or under the stairs?
Often, yes, as long as the space already exists and is usable. In a garage it needs to be dry and protected from frost, with power and a route for water and waste. Under the stairs, check the headroom, the ventilation and whether a door can open fully. We fit units and connect appliances in existing spaces; converting a garage into a habitable room is a separate building project.
Does a utility room need an extractor fan?
Yes, in most cases. Washing and drying put a lot of moisture into a small space, so extract ventilation is strongly advised: Approved Document F sets a rate of about 30 litres per second for utility rooms in England and Wales, and the building standards in Scotland and Technical Booklet K in Northern Ireland cover ventilation too. An extract fan ducted outside is the usual answer, with a window helping but not replacing it. A vented dryer needs its own duct as well.
Can a worktop go over a washing machine and dryer?
Yes, and it is one of the most common utility layouts. The worktop is supported by units, end panels or a rail at each side rather than resting on the machines, with a small gap above them for vibration and so they can be slid out for servicing. Standard front-loading machines usually fit under a standard-height worktop, but we check the appliance heights against the plan first.
Utility room fitting near Carrickfergus
Close to Carrickfergus? We cover these nearby towns too:
- Utility room fitting in Newtownabbey
- Utility room fitting in Bangor, County Down
- Utility room fitting in Larne
- Utility room fitting in Belfast
- Utility room fitting in Newtownards
- Utility room fitting in Castlereagh
- Utility room fitting across County Antrim
