Splashbacks and tiling in Hook

Thinking about splashbacks and tiling in Hook?

If your Hook home is an older property with uneven walls, the splashback may start with patching, skimming or boarding so the tiler has a flat surface to work from.

When a Hook kitchen is getting stone worktops, upstands or a matching splashback are usually planned at the same time, so they are templated in one visit. We cover all of Hook, including the KT9 postcode district, and travel out to neighbouring towns across Greater London.

What is in a typical job?

Your written quote lists everything included. For splashbacks and tiling, that normally means:

Free survey visit to check the walls, agree the layout and give an itemised quote
Tiled splashbacks between the worktop and wall units, set out from a centre line
Full-height or feature tiling behind the hob, sink or open shelving
Old tiles removed and walls prepared, patched or boarded where needed
Toughened glass splashback measured after the worktops are fitted, with socket cut-outs
Stone upstands and splashbacks templated and fitted alongside a stone worktop

Splashbacks and tiling prices in Hook

As a starting point for Hook, these ranges include VAT at 20% and allow for typical labour costs in London. Expect costs in London to sit somewhat above UK averages, reflecting local labour rates.

Splashbacks and tiling prices in Hook
Typical project	Guide price
Tiled splashbackBetween worktop and wall units	£200–£520
Kitchen wall tiling, 4–6 m²Preparation, tiling and grouting	£390–£1,000
Toughened glass splashback behind the hob, fittedMade to measure after the worktops are in	£320–£780
Stone upstands and splashbacksTemplated with the worktop	Priced with the worktop

Tiling guide ranges cover preparation, adhesive, grout, trims and fixing, with the tiles themselves confirmed once chosen; the glass range includes a made-to-measure panel, and stone upstands are priced with the worktop. Prices include VAT at 20%.

Fitting kitchens in older and newer Hook homes

The housing mix across Greater London includes Victorian and Edwardian terraces, conversion flats, mansion block flats and 1930s semis, so no two kitchen fits are quite alike. Victorian terraces often have a narrow galley beside the side return, while conversion flats and mansion blocks usually fit the kitchen into a small room or along one living-room wall.

Permit parking, red routes and flats without lifts are common, so parking suspensions, stair carries and lift bookings may need arranging before delivery day. London's mains water is hard, so limescale builds quickly on taps and boiling water taps, and a scale-reducing filter is worth planning in.

What rules apply to splashbacks and tiling in Hook?

Tiling or fitting a splashback in England needs no planning permission or building regulations approval. If sockets or switches are moved to suit the new wall finish, that is electrical work to BS 7671; adding to an existing kitchen circuit is not notifiable under Part P, but a new circuit is. Behind a gas hob, follow the hob maker's clearance instructions, and in a listed building, removing historic tiles or panelling may need listed building consent.

Conservation areas are widespread across London, so a new extractor vent on a front wall may need permission, and leaseholders usually need the freeholder's written consent first.

Planning ahead

Give fresh grout and sealant the full curing time shown on the packaging before scrubbing them or letting water sit on the joint at the back of the worktop.
Choosing stone worktops for a Hook kitchen? Ask for upstand and splashback heights to be confirmed before the template visit, not after.
If you are renting out a flat in Hook, a single glass panel or large plain tiles cut down the grout that needs cleaning at each check-out.
Pale grout behind a hob or sink shows stains quickly; a mid-grey or stain-resistant grout in narrow joints is easier to keep looking fresh.

Questions about splashbacks and tiling in Hook

How much do splashbacks and tiling cost in Hook?

For a tiled splashback, budget around £200 to £520 including VAT in Hook. That reflects typical costs in London; we confirm the actual figure in writing once we have measured up.

Do you cover all of Hook?

Yes. We work across Hook, including the KT9 postcode district, and nearby towns such as Chessington and Surbiton. Book a free survey visit and we will arrange a time that suits you.

When are splashbacks fitted during a kitchen installation?

Splashbacks go on near the end, once the worktops are fixed and the electrician has agreed where the sockets and switches will sit. Tiles need a finished worktop to start from, glass is measured off the fitted worktop, and stone upstands are templated at the same visit as the worktop. Faceplates go back on after tiling, so the sockets sit neatly against the new finish.

Can a glass splashback go behind a gas hob?

Yes, usually, as long as the glass is toughened and the hob maker's instructions allow it. Toughened glass handles heat far better than ordinary glass, but a gas hob must still keep the clearances set out in its installation instructions, so we check those before ordering. The panel is measured after the worktops are fitted and made with cut-outs for sockets, because it cannot be cut once toughened.

Can heavy tiles or stone go on any kitchen wall?

Not always. Heavy tiles such as large-format porcelain or natural stone need a backing that can carry their weight and an adhesive suited to both the tile and the wall. Old plaster, painted plaster or plasterboard may need preparing, priming or replacing with a tile backer board first. We check the wall at the survey and follow the tile and adhesive makers' guidance.

Splashbacks and tiling in neighbouring towns

We also carry out splashbacks and tiling in these towns near Hook: