Cooker hood installation in Longton

What prompts cooker hood installation in Longton?

If your Longton kitchen has an older open-flued boiler, fitting a stronger hood needs care, as it can affect the flue and should be followed by a spillage test.

Cooks across Staffordshire who fry, grill or stir-fry often find a recirculating hood leaves smells in the house, and look at ducting the air outside instead. We work throughout Longton (ST3) and across the wider Staffordshire area.

What we cover for cooker hood installation in Longton

Here is what usually goes into cooker hood installation, adjusted to your Longton kitchen after we have measured it:

Spillage test by a Gas Safe registered engineer where an open-flued appliance is present
Island and ceiling hoods fixed into the ceiling structure by two people
Power supply connected by an electrician and tested to BS 7671
Core drilling through the outside wall and an external grille fitted and sealed
Short, straight runs of rigid ducting wherever the route allows
Hood fixed at the height set by the hood and hob manufacturers

What does cooker hood installation cost in Longton?

The figures below are guide prices for Longton, including VAT and adjusted for typical costs across the West Midlands. The fixed price comes after we have measured up. Costs in the West Midlands sit close to the national guide.

What does cooker hood installation cost in Longton?
Typical project	Guide price
Like-for-like cooker hood swapSame position and ducting	£120–£240
New ducted hood through an outside wallCore drilling, ducting run and external grille	£300–£900
Island or ceiling hood installedTwo-person install, fixings to the ceiling structure	£300–£630
Recirculating hood fittedNo ducting; carbon filters need replacing	£120–£300

Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.

House types around Longton and what they mean for a kitchen

You will find Victorian terraces, 1930s semis, post-war estate houses and moorland stone cottages throughout Staffordshire. Terraces in Stoke-on-Trent often have a small kitchen in the rear offshoot, while 1930s semis and estate houses tend to have a compact kitchen beside the dining room.

Water across much of Staffordshire is moderately hard to hard, so limescale on taps and boiling water taps is worth planning for. Terraced streets with limited parking and narrow moorland lanes in the north of the county can complicate deliveries, so vehicle size and timing are planned ahead.

Regulations for kitchen work in Longton

In England, Approved Document F guidance for kitchen extract is about 30 litres per second from a cooker hood extracting outside, or 60 litres per second from a fan elsewhere in the room. A recirculating hood does not remove moisture, so another means of extract is usually needed. A new vent through the outside wall of a flat may need planning permission and the freeholder's consent, and an open-flued gas appliance in the room calls for a spillage test.

Homes within the Staffordshire part of the Peak District National Park, listed buildings and conservation areas may need consent for new vents or alterations to historic features.

Planning ahead

Before choosing a hood for your Longton kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
For an island hood in your Longton kitchen, settle the hood position before the ceiling is boarded, so timber supports can be added in the right place.
Replace the carbon filters in a recirculating hood as often as the manufacturer advises, and clean the grease filters regularly so the hood keeps working well.
If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.

Questions about cooker hood installation in Longton

How much does cooker hood installation cost in Longton?

Cooker hood installation in Longton typically costs £120 to £240 including VAT for a like-for-like cooker hood swap, based on prices in the West Midlands. Larger or more involved jobs cost more, and your price is fixed in writing after a free survey visit.

Do you cover all of Longton?

Yes. We work across Longton, including the ST3 postcode district, and nearby towns such as Stoke-on-Trent and Newcastle-under-Lyme. Book a free survey visit and we will arrange a time that suits you.

Does a cooker hood need a hole in the wall?

A ducted hood does. The usual route is a core-drilled hole through the nearest outside wall, with rigid ducting from the hood and an external grille sealed into the wall. Where the hob is far from an outside wall, the duct can sometimes run above the wall units or through a ceiling void. A recirculating hood needs no hole, but it removes no moisture.

How high should a cooker hood be above the hob?

At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.

Can a ducted cooker hood be fitted in a flat?

Often, but check consents first. A new vent through the outside wall of a flat may need planning permission and the freeholder's written consent, and some leases do not allow it at all. Where an outside vent is not possible, a recirculating hood can be fitted, with a separate extract fan or other ventilation dealing with moisture. Listed buildings may also need listed building consent.

Cooker hood installation near Longton

We also carry out cooker hood installation in these towns near Longton: