Cooker hood installation · Dyfed
Cooker hood installation in Aberystwyth
Homeowners and landlords in Aberystwyth can book us for cooker hood installation: ducted and recirculating cooker hoods fitted, with wall core drilling, ducting and an external grille.
Thinking about cooker hood installation in Aberystwyth?
Homeowners in Aberystwyth adding a hob to a new island often need a ceiling hood with solid fixings and a duct route planned before the ceiling is closed up.
If condensation runs down the windows of your Aberystwyth kitchen whenever you cook, the hood may be recirculating, undersized or ducted through a long, flexible run. Kitchens in every part of Aberystwyth are covered, and the survey visit is free wherever you are in Dyfed.
What is in a typical job?
Here is what usually goes into cooker hood installation, adjusted to your Aberystwyth kitchen after we have measured it:
- Short, straight runs of rigid ducting wherever the route allows
- Power supply connected by an electrician and tested to BS 7671
- Core drilling through the outside wall and an external grille fitted and sealed
- Hood fixed at the height set by the hood and hob manufacturers
- Survey of the hob position, duct route, outside wall and any open-flued appliance
- Island and ceiling hoods fixed into the ceiling structure by two people
Guide prices for cooker hood installation in Aberystwyth
Typical cooker hood installation prices for homes in Aberystwyth, including VAT and adjusted for Wales. Your own figure depends on the size of the kitchen, the layout and what is moving. Prices in Wales usually come in below the national guide, as labour rates are lower than in the South East.
| Typical project | Guide price |
|---|---|
| Like-for-like cooker hood swapSame position and ducting | £110–£220 |
| New ducted hood through an outside wallCore drilling, ducting run and external grille | £280–£830 |
| Island or ceiling hood installedTwo-person install, fixings to the ceiling structure | £280–£580 |
| Recirculating hood fittedNo ducting; carbon filters need replacing | £110–£280 |
Guide ranges cover fitting and connection with standard ducting through a straightforward wall; long or concealed duct runs, ceiling repairs, new electrical spurs, spillage tests and the hood itself are priced separately. Prices include VAT at 20%.
Local homes and their kitchens
The housing mix across Dyfed includes stone cottages, Victorian terraces, farmhouses and post-war bungalows, so no two kitchen fits are quite alike. Stone cottages and farmhouses often have a small kitchen in a rear extension, while terraces in Llanelli and Aberystwyth tend to have a narrow galley at the back.
Rural farm tracks, steep coastal lanes and long distances between villages can affect delivery vehicles, so worktop lengths and timing need planning ahead. Mains water across most of Dyfed is soft, so limescale is rarely a big problem, though farms on private supplies may need their own filtering.
Building regulations, electrics and gas in Aberystwyth
Wales has its own Approved Document F with the same broad rates: about 30 litres per second from a hood extracting outside, or 60 litres per second from a fan elsewhere. A recirculating hood does not remove moisture. Extending a kitchen circuit to power a hood is notifiable under Part P in Wales, and a new vent through the outside wall of a flat may need planning permission and the freeholder's consent.
Homes in the Pembrokeshire Coast National Park or Bannau Brycheiniog, listed cottages and conservation areas may need consent for a new external vent or historic alterations.
Getting the most from your cooker hood installation
- Before choosing a hood for your Aberystwyth kitchen, find the nearest outside wall to the hob, because the shorter the duct run, the better the extraction.
- Ask for rigid ducting rather than flexible hose wherever the route allows, as it moves more air, gathers less grease and is usually quieter.
- Choose a hood at least as wide as your hob, and compare its stated extraction rate with the size of the room before you buy.
- If the kitchen has an open-flued boiler or gas fire, a Gas Safe registered engineer should carry out a spillage test after the hood is fitted.
Questions about cooker hood installation in Aberystwyth
How much does cooker hood installation cost in Aberystwyth?
For a like-for-like cooker hood swap, budget around £110 to £220 including VAT in Aberystwyth. That reflects typical costs in Wales; we confirm the actual figure in writing once we have measured up.
Can you measure up in Aberystwyth before quoting?
Yes. Every quote starts with a free, no-obligation survey visit to your home in Aberystwyth. We measure the room, check the walls, floor and service positions, then send an itemised written quote.
Should I choose a ducted or a recirculating cooker hood?
A ducted hood is usually more effective, because it takes steam, smoke and smells outside. A recirculating hood passes air through grease and carbon filters and returns it to the room, so it deals with grease and smells but not moisture, and another means of extract is usually needed. Recirculating suits kitchens with no practical duct route, and its carbon filters need replacing.
Why might a cooker hood need a spillage test?
Because a hood pulling air out of a room can draw fumes back down the flue of an open-flued gas appliance, such as some older boilers or gas fires. Where the kitchen, or a room open to it, has one, a Gas Safe registered engineer should carry out a spillage test with the hood running at full speed. Room-sealed boilers are not affected in the same way.
How high should a cooker hood be above the hob?
At least the minimum distance given by the manufacturers. Both the hood and the hob instructions set a minimum gap between them, and where they differ the greater figure should be used. Gas hobs usually need more clearance than induction. A hood fitted too low is a fire risk, while one fitted much higher than recommended captures less steam.